This National Standard of Canada is identical to American National Standard
ANSI/BHMA A156.15-1981.
1.1
This Standard establishes requirements for door closers combined with hold-open
devices or free-swinging door closers combined with releasing devices and
includes performance tests covering operational, cyclical and finish criteria.
1.2
Tests described in this Standard are performed…
Machinery for forestry — Falling-object protective structures — Laboratory tests and performance req...
Establishes a consistent, repeatable means of evaluating characteristics of protective structures under loading. Applies to mobile or self-propelled specially-designed machines as defined in ISO 6814. Some figures illustrate the drop test objekt and drop test impact points. Annex A gives a standard test report; annex B contains additional information for originator of test request.
Paper and board — Compressive strength — Short span test
Specifies a method for the determination of the compressive strength in the machine and cross directions of paper and board using a short span compression tester. Applies to papers and boards used for the manufacture of containers and boxes. May also be used for laboratory sheets prepared for the testing of pulp.
Methods of Testing Petroleum and Associated Products Test for Ethyl
Mercaptan Odourant in Propane...
Intended for the semi-quantitative (i.e. ± 25%) determination of
ethyl mercaptan odourant (within the range of 5 to 85 mg/L) in
liquid propane. It is particularly appropriate to confirm that
recently stenched propane is indeed odourized to the required
level. The method is intended for field application, and may be
suitable for use by non-laboratory personnel after suitable
training. A…
CSA Safety Requirements for Electrical and Electronic Measuring and Test Equipment
1. Scope
CAN/CSA-C22.2 No. 231.0-M89 - Electrical and Electronic Measuring and Test Equipment
1.1.1 This Standard applies to electrical, electronic, or electromechanical equipment designed to
(a) measure or observe, and indicate quantities of
(i) electrical, or
(ii) electronic phenomena; or
(b) supply
(i) electrical, or
(ii) electronic quantities for measuring or…
Qualification Code for Manufacturers of Structural Glued-Laminated Timber
1. Scope
1.1 This Standard covers qualification of shop manufacturers of laminated structural timber pressure-glued by the use of clamps or mechanical means other than nailing. It does not certify the laminated timbers so produced.
1.2 This Standard sets forth requirements for determining the initial and continuing suitability of a plant's personnel, equipment, and procedures to…
Implants for surgery — Partial and total hip joint prostheses — Part 4: Determination of endurance p...
This standard defines a test method and laboratory conditions so that the important parameters that affect the components are taken into account and describes how the specimen is set up for testing. The test method has been developed for prostheses that have a plane of symmetry and may not be suitable for other designs. The standard does not cover methods of examining and reporting of the test…
Implants for surgery — Partial and total hip joint prostheses — Guidance for laboratory evaluation o...
Guidance on the measurement of changings of the form, for instance wear and tear, creeping, plastic deformation, etc., and on available procedures when the test is performed in a simulator. Sensitivity, advantages, disadvantages and the measurement equipment of the different methods are compared in a table.
Methods of testing cements — Determination of strength
Specifies a method of determining the compressive and flexural strengths of cement mortar and describes the reference procedure. Allows the use of alternative procedures only in well defined cases. Covers laboratory and equipment, mortar constituents, preparation of mortar and test specimens, curing of test specimens, and test procedures.
