Rechercher

ISO 661:2003 specifies procedures for the preparation of a test sample from a laboratory sample of animal or vegetable fats and oils for the purpose of analysis. The method is not applicable to emulsified fats such as butter, margarine or mayonnaise.

ISO 17492:2003 specifies a test method for measuring the heat transfer of horizontally mounted flame-resistant textile materials when exposed to a combination of convective and radiant energy. This test method can be used for any type of sheet material used either as a single layer or in a multilayer construction when all structures or sub-assemblies are made of flame-resistant materials. It is…

This National Standard of Canada is based on International Standard ISO 10079-2:1999 (second edition, 1999-08-15). 1 Scope This part of ISO 10079 specifies safety and performance requirements for manually powered medical suction equipment intended for oro-pharyngeal suction. It covers equipment operated by foot or by hand or both (see Figure 1). Non-electrical suction equipment which may be…

This National Standard of Canada is based on International Standard ISO 10079-3:1999 (second edition, 1999-08-15). 1 Scope This part of ISO 10079 specifies safety and performance requirements for medical suction equipment powered from a vacuum or pressure source (see Figure 1). In particular it applies to connections for pipelines and Venturi attachments. Suction equipment with components…

1. INTRODUCTION 1.1 This laboratory guide has been developed for the assessment of volatile organic compound emissions from polyurethane foam. It outlines a test procedure for the determination of volatile organic compounds from the foam and explains why certain test conditions have been selected. Upon agreement between the purchaser and the manufacturer, this test method may be used for…

ISO 16140:2003 defines the general principle and the technical protocol for the validation of alternative methods in the field of microbiological analysis of food, animal feeding stuffs and environmental and veterinary samples for the validation of alternative methods which can be used in particular in the framework of the official control, and the international acceptance of the results obtained…

ISO 15011-2:2003 provides guidance on the determination of emission rates of gases generated by arc welding using a fume box technique. It describes the test principle, gives a possible fume box arrangement and considers methods for sampling and analysis. The following gases that can be produced during arc welding are covered: - carbon monoxide (CO); - carbon dioxide (CO2); - nitrogen oxide (NO…

ISO 10381-4:2003 describes the sampling of soils of natural and near-natural sites;areas used for agriculture (arable and pasture sites);areas used for horticulture (including domestic gardens, allotments);areas used for special crop-cultivation, arboreal, vineyard, etc.;forest areas and woods. It is applicable to soil investigations and evaluations in the field;chemical, geochemical, physical,…

This part of IEC 61010 is a technical report, which provides a test protocol to assist with determining and recording verification of conformity of the equipment under test with the reference documents identified on the front cover of the appropriate report.

ISO 18922:2002 is applicable to evaluating the scratch resistance of dry, processed photographic film. It specifies two test methods for evaluating the scratch resistance on either the emulsion or the base side. The two test methods usually give comparable results. It provides empirical laboratory tests made under controlled conditions, but does not necessarily predict the actual scratch…