Rechercher

This document describes the procedures and the precautions to be taken in drawing representative samples of ethylene in the liquid phase stored at -100 °C and in the gaseous phase, for the purpose of their analysis. Annex A sets out a diagrammatic representation of a system for the disposal of the portion of the sample which is not used in the analysis.

1 Scope 1.1 This Standard applies to all types of electric cranes, including electric overhead travelling cranes, and hoists for vertical lifting and lowering of freely suspended load for voltages of 750 V and less between conductors. The equipment specified in this Standard is intended for installation in accordance with the Canadian Electrical Code, Part I. 1.2 This Standard applies to the…

Scope This National Standard of Canada applies to four types of middle distillate fuel oils that are suitable for use in liquid fuel burning equipment without preheating [types 0, 1, 2 and 2(B6-B20)], and three types of fuel oils that contain residual fuel components that require preheating (types 4, 5 and 6). The heating fuel oils covered by this standard are intended for use in oil burning…

Objet La présente Norme nationale du Canada s’applique à quatre types de mazout de distillat moyen destinés à de l’équipement à combustible liquide sans préchauffage [types 0, 1, 2 et 2(B6-B20)] et à trois types de mazout contenant des composants résiduels et nécessitant un préchauffage (types 4, 5 et 6). Les mazouts de chauffage visés par la présente norme sont destinés à de l’équipement de…

1 Scope 1.1 Purpose This Standard establishes minimum requirements for electrical work and electrical equipment operating, or intended to operate, at a mine. Note: Users should be aware that federal, provincial, and territorial legislation can impose additional requirements. 1.2 Application This Standard is supplementary to, or amendatory of, the requirements of the Canadian Electrical Code…

The requirements in this document are for part manufacturers using additive manufacturing techniques and are independent of the used material and manufacturing method. This document specifies criteria for AM relevant processes as well as quality-relevant characteristics and factors along the additive system operations and defines activities and sequences within an additive manufacturing…

This document specifies a method for the determination of the inhibition of root re-growth in duckweeds (Lemna minor) by substances and mixtures contained in water or waste water. This method applies to environmental water samples including treated municipal wastewater and industrial effluents.

This document describes the procedures and precautions to be taken in drawing representative samples of propylene and butadiene, in the liquid phase, for the purpose of their analysis. Annex A sets out a diagrammatic representation of a system for the disposal of the portion of the sample not used in the analysis. Annexes B, C and D show the sequence of operations for filling a sampling cylinder…

This document specifies a method of determining, using an Alveograph, the rheological properties of different types of dough obtained from common wheat flour (Triticum aestivum L.) produced by industrial milling or laboratory milling. It describes the Alveograph test and how to use a laboratory mill to produce flour in two stages: —    stage 1: preparation of the wheat grain for milling to make…

Le présent document spécifie une méthode de détermination des alkylphénols éthoxylés (APEO) [éthoxylate de nonylphénol (NPEOn, où 2 ≤ n ≤ 16) et éthoxylate d’octylphénol (OPEOn, où 2 ≤ n ≤ 16)] dans le cuir. Cette méthode d’analyse directe convient particulièrement lorsque les alkylphénols éthoxylés doivent être dosés sur un grand nombre d’échantillons de cuir. L’analyse est effectuée par…