Rechercher

ISO 8871-2:2003 specifies evaluation procedures applicable to elastomeric parts used for drug containers and medical devices in order to guarantee the product identity between the samples evaluated in the (suitability test) acceptance process and the current supplies. The physical and chemical test procedures specified in this part of ISO 8871 permit the determination of the typical…

ISO 1940-1:2003 gives specifications for rotors in a constant (rigid) state. It specifies balance tolerances, the necessary number of correction planes, and methods for verifying the residual unbalance. Recommendations are also given concerning the balance quality requirements for rotors in a constant (rigid) state, according to their machinery type and maximum service speed. These…

ISO 19114:2003 provides a framework of procedures for determining and evaluating quality that is applicable to digital geographic datasets, consistent with the data quality principles defined in ISO 19113. It also establishes a framework for evaluating and reporting data quality results, either as part of data quality metadata only, or also as a quality evaluation report. ISO 19114:2003 is…

1. SCOPE 1.1 This standard applies to a sealer used to prevent the release of asbestos fibres from asbestos-containing materials. This sealer is not suitable for highly friable materials.(1) 1.2 This standard helps the user to select a specific type and class of sealer, described in par. 3.1. It does not address concerns about any change in properties or characteristics of the material,…

1 Scope 1.1 This Standard applies to (a) steam sterilizers that (i) have a chamber volume of 42.5 L (1.5 ft3) or greater; and (ii) are intended for use in health care facilities; (b) emergency (flash) sterilizers; and (c) washer-disinfectors (when used in sterilizer mode). Notes: (1) In this Standard, <sterilizer> is used as a blanket term for the three types of…

ISO 11393-4:2003 specifies the requirements and test methods for gloves that are intended to provide protection against cuts by a hand-held chain-saw, including requirements for identification, marking and information for the user. The method for measurement of protective coverage, the apparatus and the test method for assessing resistance to cutting, and the ergonomic assessment are specified…

ISO 13379:2003 gives guidance for data interpretation and diagnostics of machines. It is intended to allow the users and manufacturers of condition monitoring and diagnostics systems to share common concepts in the fields of machine diagnostics; to enable users to prepare the necessary technical characteristics that will be used for the further diagnosis of the condition of the machine; and to…

Deals with the safety of commercial microwave ovens. These ovens incorporate a door for user access to the cavity. The rated voltage is less than 250 V. for single phase appliances and 480 V. for other appliances. The oven may be built into a vending machine (see also IEC 60335-2-75). The oven may also incorporate conventional heating means (see also IEC 60335-2-36 and IEC 60335-2-42). For…

ISO 19901-4:2003 contains requirements and recommendations for those aspects of geoscience and foundation engineering that are applicable to a broad range of offshore structures, rather than to a particular structure type. Such aspects are site characterization, soil and rock characterization, and design and installation of foundations supported by the seabed (shallow foundations) and the…

Contains the specific requirements for construction and assessment of intrinsically safe electrical systems, type of protection "i", intended for use, as a whole or in part, in explosive atmospheres in Group II locations. Intended for use by the designer of the system who may be a manufacturer, a specialist consultant or a member of the end-user's staff. The contents of the…