Rechercher

1.1 This Standard provides minimum requirements for shop fabricated single-wall or double-wall oil-water separators intended to collect and separate free oil from water by gravity separation at an inlet free oil concentration not exceeding 2 000 mg/L. 1.2 These oil-water separators are also installed for the capture and retention of oil spills under dry weather conditions up to the free oil…

IEC 60705:2010+A1:2014 applies to microwave ovens for household use. It also applies to combination microwave ovens. This standard defines the main performance characteristics of household microwave ovens which are of interest to the user, and it specifies methods for measuring these characteristics. This fourth edition cancels and replaces the third edition published in 1999, its amendment 1 (…

ISO 17810:2014 defines CDMA spread spectrum modulation schemes in terms of: a) the services provided to the users of this specification; b) spreading code formats; and c) the procedures performed to generate and process the code formats. It does not specify: a) individual implementations or products; b) the methods or technologies required to perform the procedures; or c) the management…

ISO 17325-1:2014 specifies the basic design requirements, general function, designations and marking of oil booms. It further specifies minimum information regarding design, dimensions and materials of oil booms to be provided by the manufacturer. The intent of ISO 17325-1:2014 is to assist manufacturers and facilitate user selection of booms by technical criteria. It does not purport to address…

1.1 The requirements specified in this Standard cover light emitting diode (LED) equipment that is an integral part of a luminaire or other lighting equipment, and which operates in the visible light spectrum between 400 and 700 nm. These requirements also cover the component parts of LED equipment, including LED controlgear, controllers, arrays, modules, and packages, as defined in this Standard…

This National Standard of Canada is based on International Standard ISO 16602:2007+A1:2012, MOD. This International Standard establishes minimum performance classification and labelling requirements for protective clothing designed to provide protection against chemicals. Protective clothing items covered by this International Standard include, but may not be limited to, totally…

1 Scope 1.1 This performance Standard applies to circular precast concrete pipe, manhole (maintenance hole) sections, and accessories intended for (a) use as sewer pipe for the conveyance of sewage, industrial wastes, and storm water; and (b) the construction of culverts. 1.2 This Standard describes the following procedures for testing circular precast concrete pipe, manhole sections, and…

1 Scope 1.1 This Standard specifies minimum requirements for masonry materials and masonry construction. Notes: 1) Requirements for structural design of masonry are specified in CSA S304. 2) If a requirement specified in Part 9 of the National Building Code of Canada differs from a requirement specified in this Standard, the requirement specified in this Standard should be followed. 3) General…

1 Scope 1.1 General This Standard specifies requirements, in accordance with the National Building Code of Canada, for the design and strength evaluation of a) structures of reinforced and prestressed concrete; b) plain concrete elements; and c) special structures such as parking structures, arches, tanks, reservoirs, bins and silos, towers, water towers, blast-resistant structures, and…

1.1 This Standard applies to motor-operated liquid pump units for use in nonhazardous, indoor, outdoor (exposed), and submerged locations and designed to be used in accordance with the Rules of the Canadian Electrical Code, Part I. 1.2 This Standard applies to a) pumps for either permanent or cord-connection to the source of supply; b) cord- and plug-connected pumps; and c) component-type…