Rechercher

ISO/IEC 24752-2:201j4 is a multi-part International Standard that aims to facilitate operation of information and electronic products through remote and alternative interfaces and intelligent agents. A user interface socket is an abstract user interface that describes the functionality and state of a device or service (target) in a machine-interpretable manner that is independent of presentation…

ISO/IEC 24752-4:2014 is a multi-part International Standard to facilitate operation of information and electronic products through remote and alternative interfaces and intelligent agents. ISO/IEC 24752-4:2014 defines an extensible markup language (XML) based language for the description of targets, as used within the universal remote console framework for discovery purposes. A document…

ISO/IEC 24752-5:2014 is a multi-part International Standard that aims to facilitate operation of information and electronic products through remote and alternative interfaces and intelligent agents. ISO/IEC 24752-5:2014 defines syntax and semantics for describing atomic resources, resource sheets, groupings, and grouping sheets relevant to the user interface of a device or service ("target…

ISO/IEC 24752-6:2014 defines the syntax and semantics for embedding target description and socket descriptions in interface specifications of web services so that there is a clear mapping between special elements in the WSDL document and elements of (implicit) target description and (implicit) socket descriptions.

IEC 60118-4:2014 is applicable to audio-frequency induction-loop systems producing an alternating magnetic field at audio frequencies and intended to provide an input signal for hearing aids operating with an induction pick-up coil (telecoil). Throughout this standard, it is assumed that the hearing aids used with it conform to all relevant parts of IEC 60118. This standard specifies requirements…

ISO 10791-6:2014 specifies, with reference to ISO 230‑1 and ISO 230‑4, certain kinematic tests for machining centres, concerning spindle speeds, feed and the accuracy of the paths described by the simultaneous movement of two or more numerically controlled (NC) linear and/or rotary axes. It applies to machining centres having three linear axes (X, Y, and Z) and additionally one or two rotary axes…

1 Scope 1.1 Mitigation techniques and other actions This Standard covers the following mitigation techniques to maintain permafrost or remediate permafrost degradation around existing buildings or structures: a) site techniques that consist of i) shading; ii) drainage and grading; and iii) ground cover and snow management; b) foundation techniques that consist of i) ventilation; ii)…

1 Scope 1.1 This Standard specifies the dimensional and material requirements for facially featured headforms to be used in the testing of full-face protection and eye protection equipment, especially impact protection testing. 1.2 In this Standard, “shall” is used to express a requirement, i.e., a provision that the user is obliged to satisfy in order to comply with the standard; “should” is…

1 Scope 1.1 This Standard deals with over-the-shoe toe protectors for temporary use and includes requirements for one grade of toe impact resistance. Note: This type of protector should not be confused with fully-integrated safety footwear (as specified in CSA Z195). 1.2 This Standard also provides requirements for slip-resisting over-the-shoe toe protectors. 1.3 For the purpose of this…

1.1 This Standard applies to arc fault protective devices designed to be installed in accordance with the Rules of the Canadian Electrical Code, Part I. 1.2 These devices include arc fault circuit interrupters (AFCI) and devices that incorporate arc fault circuit protection for use on single phase, 120 V, or single phase, two-pole, three-wire 120/240 V alternating current, 60 Hz circuits having a…