Rechercher

ISO 16369:2007 specifies particular safety requirements for mast-climbing work platforms (MCWP) which are temporarily installed and are manually or power-operated, and which are designed to be used by one or more persons from which to carry out work. ISO 16369:2007 is also applicable to permanently installed MCWPs. ISO 16369:2007 is applicable to work platforms which are elevated by a drive…

This National Standard of Canada is equivalent to International Standard IEC 61400-12-1:2007. 1 Scope This part of IEC 61400 specifies a procedure for measuring the power performance characteristics of a single wind turbine and applies to the testing of wind turbines of all types and sizes connected to the electrical power network. In addition, this standard describes a procedure to be used to…

1.1 Scope 1.1.1 This standard applies to newly produced assembled connectors constructed entirely of new, unused parts and materials. Such connectors are intended for exterior use above ground for making the following nonrigid connections: a. Between the gas supply and the gas inlet of an appliance for outdoor installation that is not frequently moved after installation. These connectors are…

ISO 22965-1:2007 applies to concrete for structures cast in situ, pre-cast structures and structural pre-cast products for buildings and civil engineering structures. The concrete can be mixed on site, ready-mixed concrete or produced in a plant for pre-cast concrete products. ISO 22965-1:2007 applies to concrete compacted to retain no appreciable amount of entrapped air other than entrained air…

1 Scope 1.1 General This Standard applies to mast-climbing work platforms (MCWPs) that are primarily used to provide a working surface for personnel, along with their necessary tools and materials, at elevated work locations. An MCWP typically includes the following features (see Figures 1 and 2): (a) one or more work platforms; (b) one or more masts that are (i) free-standing or…

ISO 21127:2006 establishes guidelines for the exchange of information between cultural heritage institutions. In simple terms this can be defined as the curated knowledge of museums. A more detailed definition can be articulated by defining both the intended scope, a broad and maximally inclusive definition of general principles, and the practical scope, which is defined by reference to a set of…

ISO 17660-1:2006 is applicable to the welding of weldable reinforcing steel and stainless reinforcing steel of load-bearing joints, in workshops or on site. It specifies requirements for materials, design and execution of welded joints, welding personnel, quality requirements, examination and testing. ISO 17660-1:2006 also covers welded joints between reinforcing steel bars and other steel…

ISO 13232-6:2005 specifies minimum requirements for: paired comparison tests;the preparation of the dummy, motorcycle and opposing vehicle;the repeatability and reproducibility of impact test conditions within and between test sites;the minimization of variation in secondary test variables;realistic and representative impact conditions for full-scale impact tests; anda means to verify analytical…

CSA Preface This is the first edition of CSA T568.1, Commercial building telecommunications cabling standard - Part 1: General requirements. It replaces CSA T529-95, Telecommunications Cabling Systems in Commercial Buildings. This Standard is an adoption of the identically titled ANSI/TIA/EIA (American National Standards Institute/Telecommunications Industry Association/Electronic…

Describes a method for calculating the minimum approach distances for live working, at maximum voltages between 72,5 kV and 800 kV. This standard addresses system overvoltages, and the working air distances between parts and/or workers at different potentials. The required withstand voltage and minimum approach distances calculated by the method described in this standard are evaluated taking…