Rechercher

ISO/TR 15655:2003 identifies test methods already in existence and provides guidance on those that need to be developed to characterize the thermo-physical and mechanical properties of structural materials at elevated temperatures for use in fire safety engineering calculations. It is applicable to materials used in load-bearing construction in which structural and thermal calculations might be…

ISO 15767:2003 provides recommendations for controlling the analytical uncertainty associated with aerosol collection medium instability, where collection medium or substrate includes any article used to collect particles (e.g. filter or foam material) as well as those supporting elements which must be analysed by weighing. ISO 15767:2003 is applicable to results compiled both from the literature…

ISO 9239-2 specifies a method for assessing the burning behaviour of horizontally mounted flooring systems exposed to a heat flux gradient in a test chamber, when ignited with pilot flames. The radiant heat gradient is higher than the one described in ISO 9239-1 in order to simulate conditions in a corridor adjacent to a room containing a fully developed fire (post-flashover). This method is…

ISO 10416:2002 provides procedures for the laboratory testing of both drilling fluid materials and drilling fluid physical, chemical and performance properties. It is applicable to both water-based and oil-based drilling fluids, as well as the base or make-up fluid. It is not intended as a detailed manual on drilling fluid control procedures. Recommendations regarding agitation and testing…

ISO/TS 11155-2:2002 specifies a test comprising methods for measuring the dynamic gas adsorption of air filters in the passenger compartments of road vehicles. These laboratory test methods are applicable to air filters that improve air quality by reducing concentrations of gaseous, odorous or hazardous components from ambient or recirculated air, or both, in the vehicle cabin. They provide a…

CAN/CSA-B181.1-02 ABS Drain, Waste, and Vent Pipe and Pipe Fittings 1. Scope 1.1 This Standard applies to acrylonitrile-butadiene-styrene drain, waste, and vent (ABS-DWV) pipe, pipe fittings, and accessories such as factory-assembled expansion joints, closet flanges, and backwater valves. 1.2 This Standard includes requirements for materials, quality of work, dimensions and tolerances…

This part of ISO/TS 11155 specifies a particulate filtration test, including the critical characteristics of equipment, test procedure and report format, for the consistent assessment of filter elements in a laboratory test rig with particle sizes larger than 0,3 μm. It is applicable to filters for removing particulate matter from external or recirculated air used for ventilating motor vehicle…

This International Standard specifies test methods and minimum performance requirements for protective clothing that relies upon the ability of the outer material to reflect intense radiant heat. The clothing covered by this International Standard is intended to provide protection against flame lick and intense radiant heat and it should be worn for short periods only. Subject to a risk…

This basic standard establishes the immunity requirements and a common reference for evaluating in a laboratory the performance of electrical and electronic equipment intended for residential, commercial and industrial application, as well as of equipment intended for electrical stations, as applicable. The purpose of this standard is to define: - test voltage and current waveforms; - ranges of…

This basic standard establishes the immunity requirements and a common reference for evaluating in a laboratory the performance of electrical and electronic equipment intended for residential, commercial and industrial application, as well as of equipment intended for electrical stations, as applicable. The purpose of this standard is to define: - test voltage and current waveforms; - ranges of…