Acoustics and vibration — Laboratory measurement of vibro-acoustic transfer properties of resilient ...
This part of ISO 10846 specifies a method for determining the dynamic transfer stiffness for translations of resilient supports, under specific preload. The method concerns the laboratory measurements of vibration transmissibility and is called the indirect method. This method is applicable to test elements with parallel flanges.
Measurements for translations normal and transverse to the flanges…
Rubber condoms for clinical trials — Measurement of physical properties
This International Standard is intended as a guideline for clinical researchers working with condoms. It suggests a
series of laboratory tests to be conducted on the products to be used in any clinical investigation, so that it will be
easier to relate the clinical results to the design and quality of the condoms used.
This International Standard is not applicable to the design of clinical…
Electrical equipment for measurement, control and laboratory use - EMC requirements
specifies minimum requirements for immunity and emissions regarding electromagnetic compatibility (EMC) for electrical equipment, operating from a supply of less than 1 000 V a.c. or 1 500 V d.c. or from the circuit being measured, intended for professional, industrial-process and educational use, including equipment and computing devices. The contents of the corrigendum of July 2002 have been…
Safety requirements for electrical equipment for measurement, control and laboratory use - Part 031:...
Deals with the safety of hand-held and hand-manipulated probe assemblies. They are for use in the interface between an electrical phenomenon and test or measurement equipment. Three main types are described:
(A) Low-voltage and high-voltage, non-attenuating probe assemblies. For voltages less lthan 63 kV. They do not incorporate active components.
(B) High-voltage attenuating or divider probe…
Safety requirements for electrical equipment for measurement, control and laboratory use - Part 2-10...
Applies to equipment intended for in vitro diagnostic (IVD) medical purposes. This is used for the examination of specimens, including blood and tissue samples, derived from the human body. The standard also covers self-test IVD medical equipment for use by lay persons.
ISO 20870 specifies laboratory procedures which are intended to imitate the effects of naturally-occurring reactions. The physical properties of interest are measured before and after the application of the specified treatments.
Guideline for Seismic Risk Reduction of Operational and Functional Components (OFCs) of Buildings
1. Scope
1.1 General
This Guideline provides information and methodology to identify and evaluate hazards caused by earthquake forces acting on operational and functional components (OFCs) and to undertake appropriate mitigation strategies and techniques. It is important to note that seismic risk reduction of OFCs is affected by the structural performance of the building, although the…
Preparation of steel substrates before application of paints and related products — Collected inform...
This Technical Report provides information on the effect of water-soluble chloride and sulfate contamination levels
on steel surfaces, before the application of paint or related products to surfaces prepared in accordance with
standard mechanical or blast-cleaning surface preparation methods.
NOTE The tolerance for water-soluble salt contamination may be different for different paint types.
This…
Measurement microphones - Part 5: Methods for pressure calibration of working standard microphones b...
Applies to working standard microphones with removable protection grids meeting the requirements of IEC 61094-4 and to laboratory standard microphones meeting the requirements of IEC 61094-1.
Describes methods of determining the pressure sensitivity by comparison with either a laboratory standard microphone that has been calibrated according to IEC 61094-2, or another working standard…
