Rechercher

This document specifies methods for measuring rolling resistance, under controlled laboratory conditions, for new pneumatic tyres designed primarily for use on passenger cars, trucks and buses. This document is not applicable to tyres intended for temporary use only. It includes a method for correlating measurement results to allow inter-laboratory comparisons. It is designed to facilitate…

This document specifies a procedure for the verification of portable power measurement equipment using a strain gauge in the laboratory. The power measurement equipment verified in accordance with this document can be used on merchant ships.

This document describes procedures to measure outgassing rates from components designed for vacuum chambers and of vacuum chambers as a whole. The outgassing rates are expected to be lower than 10−5 Pa m3 s−1 (10−2 Pa L s−1) at 23 °C and to emerge from devices that are suitable for high or ultra-high vacuum applications. The molecular mass of the outgassing species or vapour is below 300 u. The…

This document is applicable to cookstoves used primarily for cooking or water heating in domestic, small-scale enterprise, and institutional applications, typically with firepower less than 20 kW and cooking vessel volume less than 150 l, excluding cookstoves used primarily for space heating. For solar cookstoves, the provisions of this document are applicable only for evaluating cooking power,…

1 SCOPE 1.1 This Standard is applicable to the finished surface or covering of a floor extending to a maximum depth of 65 mm. This method is also applicable to the following: A Materials which cannot be tested as described in Clause 1.1 of CAN/ULC-S102, Standard Method of Test for Surface Burning Characteristics of Building Materials and Assemblies, without the use of supporting material…

1 SCOPE 1.1 This method of test for surface burning characteristics of building materials is applicable to any type of building material that, by its own structural qualities or the manner in which it is applied, is capable of supporting itself in position or may be supported in the test furnace as described in this Standard (see Appendix A) or in a manner comparable to its recommended use.…

IEC 61010-031:2015+A1:2018 specifies safety requirements for hand-held and hand-manipulated probe assemblies of the types described below, and their related accessories. These probe assemblies are for direct electrical connection between a part and electrical test and measurement equipment. They may be fixed to the equipment or be detachable accessories for the equipment. It has the status of a…

This document provides a test method for evaluating the physiological impact of protective fabric ensembles and potentially protective clothing ensembles in a series of simulated activities (phases) under defined ambient conditions. This standard test method characterizes the essential properties of fabric assemblies of a representative garment or clothing ensemble for thermo-physiological…