Rechercher

1.1 Scope [Add the following] This Standard applies to the above-noted equipment that is intended to be installed or used in accordance with CSA C22.1, Canadian Electrical Code, Part I. General requirements applicable to this Standard are provided in CAN/CSA-C22.2 No. 0.

1.1 Scope 1.1.1 Equipment included in Scope [Add the following] This Standard applies to the above-noted equipment that is intended to be installed or used in accordance with CSA C22.1, Canadian Electrical Code, Part I. General requirements applicable to this Standard are provided in CAN/CSA-C22.2 No. 0.

1 Scope and object This clause of part 1 is applicable except as follows: 1.1.1 Equipment included in scope Replacement: Replace the text by the following: This part of IEC 61010 applies to automatic and semi-automatic laboratory equipment for analysis and other purposes. Automatic and semi-automatic laboratory equipment consists of instruments or systems for measuring or modifying one or…

1 Scope and object This clause of Part 1 is applicable, except as follows: 1.1.1 Equipment included in scope Replacement: Replace the text with the following: This part of IEC 61010 specifies particular safety requirements for CABINET X-RAY SYSTEMS. A CABINET X-RAY SYSTEM is a system that contains an X-ray tube installed in a cabinet which, independently of existing architectural…

IEC 60364-7-701:2019 applies to electrical installations in indoor or outdoor locations where a bath tub and/or a shower is intended to be permanently placed in a specific location. The extent of the location containing a bath tub and/or a shower is limited by: – the lowest finished floor level; – a horizontal plane 3 m above the lowest finished floor level; – a vertical circumscribing…

This document provides recommendations and requirements on the handling, storage, processing and documentation of venous whole blood specimens intended for circulating cell free DNA (ccfDNA) examination during the pre-examination phase before an analytical test is performed. This document covers specimens collected in venous whole blood collection tubes. This document is applicable to any…

This document specifies laboratory methods for determination of the soil water-retention characteristic. This document applies only to measurements of the drying or desorption curve. Four methods are described to cover the complete range of soil water pressures as follows: a) method using sand, kaolin or ceramic suction tables for determination of matric pressures from 0 kPa to −50 kPa; b)…

This document specifies a laboratory test method to determine the degree and rate of aerobic biodegradation level of plastic materials. This test method can also be applied to other materials. Biodegradation is determined by measuring the CO2 evolved by the plastic material when exposed to marine sediments sampled from a sandy tidal zone and kept wet with salt-water under laboratory conditions.…

IEC 62885-8:2019 is applicable for measurements of the performance of mains-operated dry vacuum cleaners, including water filter vacuum cleaners, for commercial use. The requirements for the construction and testing covered by this document are applied in addition to the requirements for commercial vacuum cleaners in IEC 60335-2-69. The purpose of this document is to specify essential…

This document specifies two procedures for determining the decrease in counterforce exerted by a test piece of vulcanized or thermoplastic rubber which has been compressed to a constant deformation and maintained thus at a predetermined test temperature. The counterforce can be determined either by means of a continuous-measurement system or by a discontinuous-measurement one. Two test methods…