Reaction to fire tests for floorings — Part 1: Determination of the burning behaviour using a radian...
This part of ISO 9239 specifies a method for assessing the wind-opposed burning behaviour and spread of flame of horizontally mounted floorings exposed to a heat flux radiant gradient in a test chamber, when ignited with pilot flames. Annex A gives details of assessing the smoke development, when required.
This method is applicable to all types of flooring, e.g. textile carpet, cork, wood,…
Paints and varnishes — Determination of pH value — Part 1: pH sensors with glass membrane
ISO 19396-1:2017 specifies a method for laboratory measurement of the pH value of polymer dispersions and coating materials using pH electrodes with a glass membrane. ISO 19396‑2 specifies a method for measuring the pH value using pH electrodes with ion-sensitive field-effect transistor (ISFET) technology.
Road vehicles — Box task and detection response task to measure visual-manual and cognitive demand
This document defines key terms and parameters applied in the analysis of cognitive and visual-manual workload induced by transport information and control systems (TICS). It provides guidelines and minimum requirements on equipment and procedures for analysing cognitive and visual-manual load including assessment of TICS to:
— plan evaluation trials;
— specify (and install) data capture…
Inlet air cleaning equipment for internal combustion engines and compressors — Performance testing
This document establishes and specifies uniform test procedures, conditions, equipment and a performance report to permit the direct laboratory performance comparison of air cleaners.
The basic performance characteristics of greatest interest are air flow restriction or differential pressure, dust collection efficiency, dust capacity and oil carry-over on oil bath air cleaners. This test code…
Water quality — Estimation of measurement uncertainty based on validation and quality control data
This International Standard specifies methods for the estimation of measurement uncertainty of chemical and
physicochemical methods in single laboratories based on validation data and analytical quality control results
obtained within the field of water analysis.
NOTE 1 The principles of the estimation of uncertainty specified in this International Standard are consistent with the
principles…
Fans — Determination of fan sound power levels under standardized laboratory conditions — Part 3: En...
ISO 13347-3:2004 applies to industrial fans as defined in ISO 5801 and ISO 13349. It is limited to the determination of airborne sound emission for the specified set-ups. Vibration is not measured, nor is the sensitivity of airborne sound emission to vibration effects determined.
The sizes of fan which can be tested in accordance with ISO 13347-3:2004 are limited only by the practical aspects of…
Healthcare organization management — Guidance for healthcare organizations’ response to the surging ...
This document provides guidance and considerations for healthcare organizations to deliver diagnostic tests timely and accurately in a pandemic by leveraging innovative approaches to overcome the limitations of laboratory capacity as follows:
– mitigating threats encountered in providing diagnostic services during a pandemic;
– consideration for quality assurance of diagnostic service provision…
Fans — Determination of fan sound power levels under standardized laboratory conditions — Part 4: So...
ISO 13347-4:2004 applies to industrial fans as defined in ISO 5801 and ISO 13349. It is limited to the determination of airborne sound emission for the specified set-ups. Vibration is not measured, nor is the sensitivity of airborne sound emission to vibration effects determined.
The sizes of the fan, which can be tested in accordance with ISO 13347-4:2004, are limited only by the practical…
Accuracy (trueness and precision) of measurement methods and results — Part 6: Use in practice of ac...
The purpose is to give some indications of the way in which accuracy data can be used in various practical situations by: giving a standard method of calculating the repeatability limit, the reproducibility limit and other limits, providing a way of checking the acceptability of test results obtained under repeatability or reproducibility conditions, describing how to assess the stability of…
Road vehicles – Visibility – Requirements and recommendations for automotive interior display system...
The document concerns display systems, including their cover material, inside of a vehicle and with the purpose of providing vital information to the driver.
The display system may be located directly in front of the driver, in the middle section of the dashboard, or stretch from the driver’s side to the middle section. It relays information from the instrument cluster, navigation system,…
