Rechercher

ISO/TS 17892-9:2004 covers the determination of stress-strain relationships and effective stress paths for a cylindrical, water-saturated specimen of undisturbed, remoulded or reconstituted soil when subjected to an isotropic or an anisotropic stress under undrained or drained conditions and thereafter sheared under undrained or drained conditions within the scope of the geotechnical…

ISO/TS 17892-10:2004 specifies laboratory test methods to establish the effective shear strength parameter for soils within the scope of the geotechnical investigations according to prEN 1997-1 and -2. The test method consists of placing the test specimen in the direct shear device, applying a pre-determined normal stress, providing for draining (and wetting if required) of the test specimen, or…

ISO/TS 17892-11:2004 is intended for use in earthworks and foundation engineering. It specifies laboratory test methods to establish the coefficient of permeability of water through water-saturated soils. In the proposed laboratory tests soil specimens are subjected to a flow of water passing through the specimen. The water pressure conditions and volume of water passing through the specimens are…

ISO 16247:2004 specifies a helium test method for detecting and localising gas leaks in the exhaust systems of road vehicles equipped with an internal combustion engine, in order to improve the quality of exhaust gas measurements. In doing so, it completes the requirements of ISO 3929, applicable regulations and, depending on the leak rate for detection, ISO 13556. The method is particularly…

ISO 5263-3:2004 specifies an apparatus and the procedures for the laboratory wet disintegration of mechanical pulps that exhibit latency. This apparatus and procedure are required for preparation of the test portion in a number of other International Standards dealing with pulps. ISO 5263-3:2004 is applicable to all kind of mechanical pulps (i.e. mechanical, semi-chemical and chemo-mechanical…

ISO 5263-2:2004 specifies an apparatus and the procedures for the laboratory-wet disintegration of mechanical pulps that do not exhibit latency or pulps where latency has already been removed. This apparatus and procedure are required for preparation of the test portion in a number of other International Standards dealing with pulps. In principle, this method is applicable to all kind of…

ISO 13347-4:2004 applies to industrial fans as defined in ISO 5801 and ISO 13349. It is limited to the determination of airborne sound emission for the specified set-ups. Vibration is not measured, nor is the sensitivity of airborne sound emission to vibration effects determined. The sizes of the fan, which can be tested in accordance with ISO 13347-4:2004, are limited only by the practical…

ISO 13347-3:2004 applies to industrial fans as defined in ISO 5801 and ISO 13349. It is limited to the determination of airborne sound emission for the specified set-ups. Vibration is not measured, nor is the sensitivity of airborne sound emission to vibration effects determined. The sizes of fan which can be tested in accordance with ISO 13347-3:2004 are limited only by the practical aspects of…

ISO 17313:2004 specifies a test method for laboratory measurement of the hydraulic conductivity of water-saturated porous materials using a flexible wall permeameter. ISO 17313:2004 is applicable to undisturbed or compacted specimens that have a hydraulic conductivity between 1 x 10-5 m/s (1 x 10-3 cm/s) and 1 x 10-11 m/s (1 x 10-9 cm/s). Typical soil types falling in this category are clay, clay…

Establishes a common and reproducible reference for evaluating the immunity of electrical and electronic equipment when subjected to electrical fast transient/bursts on supply, signal, control and earth ports. The test method documented in this part of IEC 61000-4 describes a consistent method to assess the immunity of an equipment or system against a defined phenomenon. The standard defines…