Rechercher

1. SCOPE 1.1 This method of test for surface burning characteristics of building materials is applicable to any type of building material that, by its own structural qualities or the manner in which it is applied, is capable of supporting itself in position or may be supported in the test furnace as described in this standard or in a manner comparable to its recommended use. 1.2 The…

1. SCOPE 1.1 This Standard is applicable to the finished surface or covering of a floor extending to a maximum depth of 65 mm. This method is also applicable to the following: A Materials which cannot be tested as described in Clause 1.1 of CAN/ULC-S102 without the use of supporting material that is not representative of the intended installation; B Materials which, when tested in the…

ISO 2285:2007 specifies a number of methods of determining the dimensional changes in test pieces of vulcanized or thermoplastic rubber during and after tensile loading for relatively short periods under constant elongation or constant loading. The constant-elongation test is intended to measure the ability of rubbers to retain their elastic properties after extension, at a standard laboratory…

ISO 11452-8:2007 specifies tests for the electromagnetic immunity of electronic components for passenger cars and commercial vehicles, regardless of the propulsion system (e.g. spark-ignition engine, diesel engine, electric motor), to magnetic fields generated by power transmission lines and generating stations and some powerful electrical equipment, such as motors. To perform this test, the…

ISO 15181-2:2007 specifies the apparatus and analytical method for determining the amount of copper (based) biocide that has been released from an antifouling paint into artificial seawater in accordance with the procedure given in ISO 15181-1. It determines the copper-ion concentration and gives the final calculation for the release rate of copper under the specified laboratory conditions. It is…

ISO 15181-3:2007 specifies the apparatus and analytical method for determining the amount of zineb that has been released from an antifouling paint into artificial seawater in accordance with the procedure given in ISO 15181-1. Zineb is released from antifouling paints in the form of ionic ethylene-bis(dithiocarbamate) which is unstable in the marine environment. This part of ISO 15181 describes…

Demonstrates how to estimate the uncertainty of steady-state temperature and humidity conditions in temperature and humidity chambers. Since this is inextricably linked to the methods of measurement, these are also described. This standard is equally applicable to all environmental enclosures, including rooms or laboratories. The methods used apply both to temperature chambers and combined…

ISO 9459-5:2007 specifies a method for outdoor laboratory testing of solar domestic hot-water (SDHW) systems. The method may also be applied for in-situ tests, and also for indoor tests by specifying appropriate draw-off profiles and irradiance profiles for indoor measurements. The system performance is characterized by means of whole-system tests using a 'black-box' approach, i.e. no…

ISO 17593:2007 specifies requirements for in vitro measuring systems for self-monitoring of vitamin-K antagonist therapy, including performance, quality assurance and user training and procedures for the verification and validation of performance by the intended users under actual and simulated conditions of use. ISO 17593:2007 pertains solely to prothrombin time measuring systems used by…

ISO/TS 19700:2007 describes a tube-furnace method for the generation of fire effluent for the identification and measurement of its constituent combustion products, in particular, the yields of toxic products under a range of fire decomposition conditions. The test method described in ISO/TS 19700:2007 can be used solely to measure and describe the properties of materials, products or systems in…