Rechercher

ISO 23210:2009 specifies a standard reference method for the determination of PM10 and PM2,5 mass concentrations at stationary emission sources by use of two-stage impactors. The measurement method is especially suitable for measurements of mass concentrations below 40 mg/m3 as half-hourly averages in standard conditions (273 K, 1 013 hPa, dry gas). It is an acceptable method for the measurement…

ISO 28079:2009 specifies a method for measuring the Palmqvist toughness of hardmetals and cermets at room temperature by an indentation method. ISO 28079:2009 applies to a measurement of toughness, called Palmqvist toughness, calculated from the total length of cracks emanating from the corners of a Vickers hardness indentation, and it is intended for use with metal-bonded carbides and…

This National Standard of Canada is equivalent to International Standard CEI/IEC 61010-2-020:2006. 1 Scope and object This clause of Part 1 is applicable except as follows: 1.1 Scope Replacement: This Part 2 is applicable to electrically powered LABORATORY CENTRIFUGES. NOTE If all or part of the equipment falls within the scope of one or more other Part 2 standards of IEC 61010 as well as…

ISO 9370:2009 specifies methods for the instrumental measurement of irradiance on a planar surface. This includes not only natural solar radiation but also intensified natural solar radiation and radiation produced by laboratory light sources. For measurement of solar radiation for natural weathering and accelerated natural weathering, instrumental techniques include the continuous measurement of…

ISO 28580:2009 specifies methods for measuring rolling resistance, under controlled laboratory conditions, for new pneumatic tyres designed primarily for use on passenger cars, trucks and buses. Tyres intended for temporary use only are not included in ISO 28580:2009. ISO 28580:2009 includes a method for correlating measurement results to allow inter-laboratory comparisons. Measurement of tyres…

IEC 61482-1-1:2009 specifies test methods to measure the arc thermal performance value of materials intended for use in heat- and flame-resistant clothing for workers exposed to the thermal effects of electric arcs and the function of garments using these materials. These test methods measure the arc thermal performance value of materials which meet the following requirements: less than 100 mm…

ISO 15767:2009 provides recommendations for controlling the analytical uncertainty associated with aerosol collection medium instability, where collection medium or collection substrate includes any article used to collect particles (e.g. filter or foam material) as well as those supporting elements which must be analysed by weighing. ISO 15767:2009 is applicable to results compiled both from the…

ISO 15193:2009 specifies requirements for the content of a reference measurement procedure for in vitro diagnostic medical devices and medical laboratories. ISO 15193:2009 applies to reference measurement procedures providing values of differential or rational quantities. Annex A provides information on nominal properties and ordinal quantities. ISO 15193:2009 is valid for any person, body or…

ISO/TS 12389:2009 describes the results of the inter-laboratory testing of the chemical analysis of cement by x-ray fluorescence. In the first instance, the inter-laboratory testing was carried out in Japan and Asian countries in accordance with JIS R 5204:2002. A total of 30 laboratories, 16 in Japan and 14 outside Japan, participated in the original testing programme. A further 12 European…