Rechercher

IEC 61010-2-201:2013 specifies the complete safety requirements for control equipment (e.g. programmable controller (PLC)), the components of Distributed Control Systems, I/O devices, Human Machine Interface (HMI)). Safety terms of general use are defined in IEC 61010-1. More specific terms are defined in each part. This part incorporates the safety related requirements of Programmable…

IEC/TS 62850:2013 specifies general safety requirements for the following types of equipment and their accessories intended to be used in educational establishments by persons between the age of 3 years and the age of 16 years under the supervision of the RESPONSIBLE BODY. If all or part of the equipment falls within the scope of one or more part 2 standards of IEC 61010 as well as within the…

ISO 6529:2013 describes laboratory test methods to determine the resistance of materials used in protective clothing, including gloves and including footwear, when the footwear is an integral part of the clothing, to permeation by liquid or gaseous chemicals under the conditions of either continuous or intermittent contact. Method A is applicable to testing against liquid chemicals, either…

ISO 717-1:2013: a) defines single-number quantities for airborne sound insulation in buildings and of building elements such as walls, floors, doors, and windows; b) takes into consideration the different sound level spectra of various noise sources such as noise sources inside a building and traffic outside a building; c) gives rules for determining these quantities from the results of…

ISO 16413:2013 specifies a method for the evaluation of thickness, density and interface width of single layer and multilayered thin films which have thicknesses between approximately 1 nm and 1 μm, on flat substrates, by means of X-Ray Reflectometry (XRR). This method uses a monochromatic, collimated beam, scanning either an angle or a scattering vector. Similar considerations apply to the case…

ISO 17715:2013 specifies the determination of the damage to starch using an amperometric method. It is applicable to all flour samples from industrial or laboratory milling of wheat (Triticum aestivum L.).

IEC 60704-2-14:2013 specifies the measuring conditions to provide for sufficient accuracy in determining the noise emitted and comparing the results of measurements taken by different laboratories, whilst simulating as far as possible the practical use of household refrigerators, frozen-food storage cabinets and food freezers. It is recommended to consider the determination of noise levels as…

IEC 60704-2-14:2013 specifies the measuring conditions to provide for sufficient accuracy in determining the noise emitted and comparing the results of measurements taken by different laboratories, whilst simulating as far as possible the practical use of household refrigerators, frozen-food storage cabinets and food freezers. It is recommended to consider the determination of noise levels as…

ISO 2285:2013 specifies a number of methods of determining the dimensional changes in test pieces of vulcanized or thermoplastic rubber during and after tensile loading for relatively short periods under constant elongation or constant loading. The constant-elongation test is intended to measure the ability of rubbers to retain their elastic properties after extension, at a standard laboratory…