Rechercher

This part of ISO 10079 specifies safety and performance requirements for medical suction equipment powered from a vacuum or positive pressure gas source generating venturi suction. It applies to equipment connected to medical gas pipeline systems or cylinders and venturi attachments. Annex D illustrates the three parts of ISO 10079 by providing a schematic for typical systems. The equipment can…

ISO 16000-30:2014 specifies sensory testing and the evaluation of indoor odours using human panels. Sensory testing can be performed on site or in laboratories; in the latter case, by means of air in sampling containers which were collected from the site. The olfactory testing is appropriate for office and administration buildings, assembly halls, residential buildings, and other habitable rooms…

ISO 16251-1:2014 specifies a laboratory measurement method to determine the improvement of impact sound insulation by a floor covering when laid on a standard concrete floor mock-up and excited by a standard tapping machine. The method is restricted to soft, flexible floor coverings, which transmit impact sound mainly "locally" into the floor, i.e. through the area close to the points…

ISO 14388-1:2014 provides a general introduction to acid sulfate soils and the approaches that can be used to measure the various components of this special group of soils and their potential to produce acidity. It provides a compilation of the test methods, identification and definitions of the symbols, terms, and acronyms used in this series of ISO 14388. While part of the decision-making…

ISO Guide 80 outlines the essential characteristics of reference materials for quality control (QC) purposes, and describes the processes by which they can be prepared by competent staff within the facility in which they will be used (i.e. where instability due to transportation conditions is avoided). The content of this Guide also applies to inherently stable materials, which can be transported…

ISO 5631-3:2014 specifies a method for measuring the colour of paper and board by the diffuse reflectance method with the elimination of specular gloss. ISO 5631-3:2014 is primarily intended for measuring the colour of paper and board to be used in the graphic arts industry, where that industry specifies the measurement of colour under D50/2° conditions in accordance with ISO 13655. This method…

ISO 5631-2:2014 specifies a method for measuring the colour of paper and board by the diffuse reflectance method with the elimination of specular gloss. It can be used to determine the colour of papers or boards that contain fluorescent whitening agents, provided the UV content of the illumination on the test piece has been previously adjusted to give the calibrated colourimetric value…

ISO/TS 19159-1:2014 defines the calibration and validation of airborne and spaceborne remote sensing imagery sensors. The term "calibration" refers to geometry, radiometry, and spectral, and includes the instrument calibration in a laboratory as well as in situ calibration methods. The validation methods address validation of the calibration information.

ISO 17289:2014 specifies an optical method for the determination of dissolved oxygen in water using a sensor working on the basis of fluorescence quenching. Measurement can be made either as a concentration of oxygen in milligrams per litre, percentage saturation (% dissolved oxygen), or both. Depending on the instrument used, detection limits of 0,1 mg/l or 0,2 mg/l can be reached according to…

ISO 11617:201 specifies laboratory exposure procedures for determining the effects of cyclic movement and artificial weathering on cured, elastic weatherproofing joint sealants (one- or multi-component).