Rechercher

This document specifies a laboratory method for the determination of the distillation characteristics of light and middle distillates derived from petroleum and related products of synthetic or biological origin with initial boiling points above 0 °C and end-points below approximately 400 °C, utilizing either manual or automated equipment. Light distillates are typically automotive engine petrol…

For the determination of the watertightness of a joint a method has still not been elaborated. Because of the fundamental importance of this property, solutions are proposed, by way of examples, that experiences and laboratory studies have shown to be satisfactory under the usual conditions. Is applicable to all public or private buildings, used as dwellings, offices, educational or hospital…

For the determination of the watertightness of a joint a method has still not been elaborated. Because of the fundamental importance of this property, a solution is proposed, by way of an example, that experience and laboratory studies have shown to be satisfactory under the usual conditions. Is applicable to public or private buildings, used as dwellings, offices, educational or hospital…

ISO 10121-1:2014 aims to provide an objective laboratory test method, a suggested apparatus, normative test sections and normative tests for evaluation of three different solid gas-phase air cleaning media (GPACM) or GPACM configurations for use in gas-phase air cleaning devices intended for general filtration applications. ISO 10121-1:2014 is specifically intended for challenge testing and not…

Of the test methods presented (strength test for the structure, endurance test), only some may be required depending on the type of tyre to be tested. The tests are carried out in a laboratory under controlled conditions. Applies to all truck and bus tyres.

This standard shall be used as the basis for testing electrically powered air circulating fan heads and ceiling fans when air is used as the test gas. The scope is limited to air circulating fans with an input power greater than or equal to 125 W—except for ceiling fans that are larger than 1800 mm, which do not have a lower input power limit. The diameter of the fan being tested shall be limited…

This document corresponds to the subsequent part of ISO 23300-1 "General requirements and test methods for rail welding" and specifies the requirements on rail aluminothermic welding, including the requirements for approval of an aluminothermic welding process, laboratory tests, contractor/welder, as well as the acceptance criteria of aluminothermic welds in track. In this document, 43…

This document defines key terms and parameters applied in the analysis of cognitive and visual-manual workload induced by transport information and control systems (TICS). It provides guidelines and minimum requirements on equipment and procedures for analysing cognitive and visual-manual load including assessment of TICS to: — plan evaluation trials; — specify (and install) data capture…

ISO 4582:2017 specifies methods to determine changes in colour and other appearance properties, and variations in mechanical or other properties, of plastics that have been exposed to glass-filtered solar radiation, to natural weathering or to simulated solar radiation from a laboratory source. The procedure used to analyse data depends on whether the test used to characterize the materials being…

This International Standard proposal specifies technical requirements and evaluation method for temperature correction on temperature measurement in radiosonde due to solar radiation in sounding experiment. This International Standard is applicable to the correction of temperature measurement traceable to SI unit in radiosonde boom sensors according to variations of pressure and air speed under…