Implants for surgery — Partial and total hip joint prostheses — Part 4: Determination of endurance p...
This standard defines a test method and laboratory conditions so that the important parameters that affect the components are taken into account and describes how the specimen is set up for testing. The test method has been developed for prostheses that have a plane of symmetry and may not be suitable for other designs. The standard does not cover methods of examining and reporting of the test…
Implants for surgery — Partial and total hip joint prostheses — Guidance for laboratory evaluation o...
Guidance on the measurement of changings of the form, for instance wear and tear, creeping, plastic deformation, etc., and on available procedures when the test is performed in a simulator. Sensitivity, advantages, disadvantages and the measurement equipment of the different methods are compared in a table.
Methods of testing cements — Determination of strength
Specifies a method of determining the compressive and flexural strengths of cement mortar and describes the reference procedure. Allows the use of alternative procedures only in well defined cases. Covers laboratory and equipment, mortar constituents, preparation of mortar and test specimens, curing of test specimens, and test procedures.
Tool life testing in milling — Part 1: Face milling
Specifies recommended procedures for tool-life testing with cemented carbide tools used for face milling of steel and cast iron workpieces. Can be applied to laboratory as well as to production practice. Considers conditions as a result of which tool deterioration is due to wear. Establishes specifications for workpiece, tool, cutting fluid, cutting conditions, equipment, assessment of tool…
Tool life testing in milling — Part 2: End milling
specifies recommended procedures for tool-life testing with high-speed steel tools used for end milling of steel and cast iron workpieces. Can be applied to laboratory as well as to production practice. Considers conditions under which tool deterioration is mainly due to wear. Establishes specifications for workpiece, tool, cutting fluid, cutting conditions, equipment, assessment of tool…
Procedure given applies to gases, such as propane, butane or mixtures thereof. It is suitable for sampling into containers to provide samples for laboratory testing of products covered by ISO 9162. Although this procedures can be used to provide samples for compositional analysis, it is strongly recommended that alternative apparatus, such as a variable-volume container, be used to minimize…
Ferronickel ingots or pieces — Sampling for analysis
Applies to ferronickel lots in ingot or piece form with a view to obtaining a representative laboratory sample for the determination of the chemical composition of the lot. A choice is to be made between a first procedure that can be applied at the producer's plant during casting or a second procedure that can be applied to lots as delivered at the buyer's premises. Includes two…
Practical thermal properties of building materials and products
Deals only with thermal characteristics of building materials and products related to thermal conductivity or thermal resistance. Gives the procedures needed to correct laboratory test values to practical values for these products.
Road vehicles — Calibration fluid for diesel injection equipment
Specifies the requirements for a calibration fluid with which diesel injection equipment may be calibrated and tested in production, in service, and in laboratories. Tabulates characteristics, units of measurement, desired values, and methods of determination. This second edition cancels and replaces the first edition (1978).
Covers vacuum breakers for use on laboratory faucets in a nominal
pipe size of 3/8 only, although inlet or outlet connections, or
both, may be different when so required for special
installations.
