Rechercher

ISO 8178-11:2006 specifies the measurement and evaluation methods for gaseous and particulate exhaust emission from reciprocating internal combustion (RIC) engines under transient conditions on a test bed, necessary for determining one value for each exhaust gas pollutant. The specific transient test cycle covered by ISO 8178-11:2006 is applicable to compression-ignition engines for mobile use…

ISO 16312-1:2006 provides technical criteria and guidance for evaluating physical fire models (i.e. laboratory combustion devices and operating protocols) used in effluent toxicity studies for obtaining data on the effluent from products and materials under fire conditions relevant to life safety. Relevant analytical methods, calculation methods, bioassay procedures and prediction of the toxic…

determines the coupling or screening attenuation of metallic communication cables in the frequency range of 30 MHz to 1 000 MHz. It is an alternative method to the injection clamp method of IEC 62153-4-3 or the triaxial method of IEC/ PAS 62338. Due to the undefined outer circuit of this absorbing clamp method, the test results obtained at different places and laboratories could vary by at least…

ISO 10848-3:2006 applies to structurally connected light elements forming a T or X junction. The performance of the building components is expressed either as an overall quantity for the combination of elements and junction, or as the vibration reduction index of a junction.

ISO 10848-2:2006 applies to light elements such as suspended ceilings, access floors, light uninterrupted façades or floating floors. The transmission from one room to another can be simultaneous through the test element and via the plenum, if any. With measurements according to ISO 10848-2:2006, the total sound transmission is measured, and it is not possible to separate the two kinds of…

ISO 10848-1:2006 contains definitions, general requirements for test specimens and test rooms, and methods for measurement of the flanking transmission. Guidelines are given for the selection of the quantity to be measured depending on the junction and the types of building elements involved.

ISO 15011-4:2006 covers health and safety in welding and allied processes. ISO 15011-4:2006 specifies requirements for determination of the emission rate and chemical composition of welding fume in order to prepare fume data sheets.. It applies to all filler materials used for joining or surfacing by arc welding using a manual, partly mechanised or fully automatic process, depositing unalloyed…

ISO/TS 20281:2006 offers guidance on statistical methods used for the analysis of data of standardized ecotoxicity tests. It focuses on statistical methods for obtaining statistical estimates of parameters. The methods described are intended to cover laboratory ecotoxicity tests (aquatic, sediment and/or terrestrial tests), and may also be relevant for other toxicity tests. Hypothesis testing,…

ISO/TS 15011-5:2006 specifies procedures for obtaining information about thermal degradation products generated when welding, cutting through, preheating and straightening products composed wholly or partly of organic substances, e.g. shop primers, paints, adhesives, waxes, sealants, pressing lubricant, oils, etc. It is aimed primarily at test laboratories performing such procedures. The data…

ISO 4892-3:2006 specifies methods for exposing specimens to fluorescent UV radiation and water in apparatus to designed reproduce the weathering effects that occur when materials are exposed in actual end-use environments to daylight, or to daylight through window glass. The specimens are exposed to fluorescent UV lamps under controlled environmental conditions (temperature, humidity and/or water…