Rechercher

ISO 7218:2007 gives general requirements and guidance/options intended for three main uses: implementation of ISO TC34/SC9 or TC34/SC5 standards for detection or enumeration of microorganisms;good laboratory practices for food microbiological laboratories (the purpose is not to detail them in this International Standard, manuals are available for that purpose);guidance for accreditation of food…

1. SCOPE 1.1 This method of test for surface burning characteristics of building materials is applicable to any type of building material that, by its own structural qualities or the manner in which it is applied, is capable of supporting itself in position or may be supported in the test furnace as described in this standard or in a manner comparable to its recommended use. 1.2 The…

1. SCOPE 1.1 This Standard is applicable to the finished surface or covering of a floor extending to a maximum depth of 65 mm. This method is also applicable to the following: A Materials which cannot be tested as described in Clause 1.1 of CAN/ULC-S102 without the use of supporting material that is not representative of the intended installation; B Materials which, when tested in the…

ISO 4582:2007 describes procedures used to determine changes in colour and other appearance properties, and variations in mechanical or other properties, of plastics that have been exposed to daylight behind glass, to natural weathering or to light from a laboratory source. The procedure used to analyse data depends on whether the test used to characterize the materials being exposed is…

ISO 2285:2007 specifies a number of methods of determining the dimensional changes in test pieces of vulcanized or thermoplastic rubber during and after tensile loading for relatively short periods under constant elongation or constant loading. The constant-elongation test is intended to measure the ability of rubbers to retain their elastic properties after extension, at a standard laboratory…

ISO 23667:2006 specifies the requirements and test methods for compatibility testing of polyethylene-based plastics Intermediate Bulk Containers (IBCs) and composite IBCs with plastics inners containing liquids. The testing involves storage with the packaged substance, or with a standard liquid as defined in Annex A. Annex B describes small scale laboratory tests, which may be used to determine…

ISO 814:2007 specifies a method for determining the adhesion strength of rubber-to-metal bonds where the rubber part is assembled between two parallel metal plates, using the adhesive system under investigation. The method is applicable primarily to test pieces, prepared in the laboratory under standard conditions, such as can be used to provide data for the development of rubber compounds and…

ISO 1827:2007 specifies methods for the determination of the modulus in shear and the strength of bonds of rubber to metal or other rigid plates, using rubber bonded between four parallel plates. The methods are applicable primarily to test pieces prepared in the laboratory under standard conditions, such as can be used to provide data for the development and control of rubber compounds and…

B64.0-07 1 Scope 1.1 The CSA B64 Series of Standards covers vacuum breakers and backflow preventers that are used in potable water supply systems to prevent cross-connections. 1.2 This Standard specifies definitions, general requirements, test methods, markings, and instructions that are common to some or all of the CSA B64 Series. 1.3 This Standard is not a complete Standard in…

1. SCOPE 1.1 This method describes two procedures for evaluating the visual haze of distillate fuel oils. 1.1.1 This method also applies to biodiesel fuel blends. 1.2 Procedure A (Field Evaluation) is a rapid field procedure used to rate the visual haze of distillate fuel oils at ambient temperatures. Procedure B (Laboratory Evaluation) is a laboratory procedure used to rate the visual haze of…