Rechercher

ISO 7263:2011 specifies two methods for the determination of the flat crush resistance of a corrugating medium after laboratory fluting. The procedures are applicable to any corrugating medium intended to be used, after fluting, in the manufacture of corrugated board.

B181.0-11 Definitions, general requirements, and methods of testing for thermoplastic nonpressure piping 1 Scope 1.1 This Standard covers thermoplastic nonpressure piping, including (a) drain, waste, and vent pipe and pipe fittings; (b) sewer and storm pipe and pipe fittings; and (c) accessories such as factory-assembled expansion joints, closet flanges, backwater valves, and cleanouts. 1.2…

ISO 5264-2:2011 specifies a method for the laboratory beating of pulp using a PFI mill. The description is limited to the sampling, preparation and beating of the pulp and the beating equipment. In principle, this method is applicable to all kinds of chemical and semi-chemical pulps. In practice, the method might not give satisfactory results with certain pulps having extremely long fibres.

ISO 28080:2011 specifies a generic test method to determine the abrasion wear characteristics of hardmetals. The procedure complements the ASTM G65 method for dry sand/rubber wheel abrasion, the ASTM B611 method for abrasive wear resistance of cemented carbides, and the ASTM G105 method for conducting wet sand/rubber wheel abrasion tests. The test is appropriate for use in situations where test…

ISO 28927-11:2011 specifies a laboratory method for measuring hand-transmitted vibration emission at the handles of hand-held stone hammers. It is a type-test procedure for establishing the magnitude of vibration in the gripping areas of a stone hammer when operated in laboratory conditions. It is intended that the results be used to compare different models of the same type of machine. ISO 28927…

ISO 3405:2011 specifies a laboratory test method, utilizing either manual or automated equipment, for determining the distillation characteristics of light and middle distillates derived from petroleum and having initial boiling points above 0 °C and end points below approximately 400 °C.

ISO/IEC 24709-3:2011 defines a number of test assertions written in the assertion language specified in ISO/IEC 24709-1:2007. These assertions enable a user of ISO/IEC 24709-3:2011 (such as a testing laboratory) to test the conformance to ISO/IEC 19784-1 (BioAPI 2.0) of any BioAPI Framework that claims to be a conforming implementation of ISO/IEC 19784-1. Each test assertion specified in ISO/IEC…

ISO/IEC 24709-3:2011 defines a number of test assertions written in the assertion language specified in ISO/IEC 24709-1:2007. These assertions enable a user of ISO/IEC 24709-3:2011 (such as a testing laboratory) to test the conformance to ISO/IEC 19784-1 (BioAPI 2.0) of any BioAPI Framework that claims to be a conforming implementation of ISO/IEC 19784-1. Each test assertion specified in ISO/IEC…

ISO 10302-1:2011 specifies methods for measuring the airborne noise emitted by small air-moving devices (AMDs), such as those used for cooling electronic, electrical, and mechanical equipment where the sound power level of the AMD is of interest. Examples of these AMDs include propeller fans, tube-axial fans, vane-axial fans, centrifugal fans, motorized impellers, and their variations. ISO 10302…

1 Scope 1.1 This Standard describes the test procedures, test set-ups, and calculations required to determine the performance, capacities, energy consumption, and overall efficiency of gas-fired and oil-fired combined space and water heating systems (combos). 1.2 This Standard establishes laboratory methods for testing and rating the thermal performance and electrical energy use of a combo…