Rechercher

ISO 30013:2011 specifies methods for the exposure of rubber and plastics hoses to three types of laboratory light source (xenon-arc, fluorescent UV and open-flame carbon-arc lamps). These methods are designed to simulate the exposure of hoses used in an outdoor environment or in an indoor environment. Four types of test piece (two strained and two unstrained upon exposure) are specified. Results…

ISO 15011-5:2011 specifies procedures for obtaining information about thermal degradation products generated when welding, cutting through, preheating and straightening metal treated with coatings composed wholly or partly of organic substances, e.g. shop primers, paints, oils, waxes and inter‑weld materials such as adhesives and sealants. It is aimed primarily at test laboratories performing…

ISO 16371-1:2011 specifies fundamental parameters of computed radiography systems with the aim of enabling satisfactory and repeatable results to be obtained economically. The techniques are based both on fundamental theory and test measurements. ISO 16371-1:2011 specifies the performance of computed radiography (CR) systems and the measurement of the corresponding parameters for the system…

IEC 60695-7-3:2011 concerns laboratory tests used to measure the toxic components of the fire effluent from either electrotechnical products or materials used in electrotechnical products. It provides guidance on the use and interpretation of results from such tests. It discusses currently available approaches to toxic hazard assessment consistent with the approach of ISO TC 92 SC 3, as set out…

ISO 5600:2011 specifies a method for the determination of the static vulcanized adhesion strength of rubber compounds to rigid materials. The test piece is composed of two conical ends of the rigid material, joined by a cylinder of rubber. The adhesion is obtained by a bonding system which can include not only the rigid material and the rubber compound, but other elements such as thin alloy…

ISO 5603:2011 specifies two methods for determining the adhesion strength of vulcanized rubber to wire cord which is embedded in the rubber. The two methods do not necessarily give the same results. They are applicable primarily to test pieces prepared in the laboratory under standard conditions and used for the development and control of materials and processes utilized in the manufacture of…

ISO 10640:2011 provides a methodology to assess the ageing of polymeric systems during exposure to laboratory accelerated weathering as well as in outdoor exposures. This methodology applies mainly to photoageing, but it can also be applied to thermal ageing. The methodology identifies analyses that follow the chemical changes which control the deterioration of physical properties of materials…

ISO 6272-2:2011 describes a method for evaluating the resistance of a dry film of paint, varnish or related product to cracking or peeling from a substrate when it is subjected to a deformation caused by a falling weight, dropped under standard conditions, acting on a small-area spherical indenter. NOTE The terms "impact" and "impact resistance" are used in the title…

ISO 1853:2011 specifies the requirements for the laboratory testing of the volume resistivity of specially prepared test pieces of vulcanized or thermoplastic rubber compounds rendered conducting or dissipative by the inclusion of carbon black or ionizable materials. The tests are suitable for materials with a resistivity of less than about 108 ohm metres. Method 1 is the preferred method when…