Rechercher

ISO 4150:2011 specifies a routine method for carrying out size analysis of green coffee by manual and machine sieving using laboratory test sieves.

IEC 60312-1:2010+A1:2011(E) applicable for measurements of the performance of dry vacuum cleaners for household use in or under conditions similar to those in households. The purpose of this document is to specify essential performance characteristics of dry vacuum cleaners being of interest to the users and to describe methods for measuring these characteristics. Due to influence of…

ISO 1827:2011 specifies methods for the determination of the modulus in shear and the strength of bonds of rubber to metal or other rigid plates, using rubber bonded between four parallel plates. The methods are applicable primarily to test pieces prepared in the laboratory under standard conditions, such as can be used to provide data for the development and control of rubber compounds and…

B64.0-11 - Definitions, general requirements, and test methods for vacuum breakers and backflow preventers 1 Scope 1.1 The CSA B64 Series covers vacuum breakers and backflow preventers that are used in potable water supply systems to prevent cross-connections. 1.2 This Standard specifies definitions, general requirements, test methods, markings, and instructions that are common to…

ISO/IEC 18013-4:2011 specifies the test methods used for conformity testing, that is methods for determining whether a driving licence can be considered to comply with the requirements of ISO/IEC 18013 for: machine readable technologies (ISO/IEC 18013-2), and access control, authentication and integrity validation (ISO/IEC 18013-3). The test methods specified in ISO/IEC 18013-4:2011 are based…

ISO/IEC 18013-4:2011 specifies the test methods used for conformity testing, that is methods for determining whether a driving licence can be considered to comply with the requirements of ISO/IEC 18013 for: machine readable technologies (ISO/IEC 18013-2), and access control, authentication and integrity validation (ISO/IEC 18013-3). The test methods specified in ISO/IEC 18013-4:2011 are based…

IEC 60475:2011 is applicable to the procedure to be used for insulating liquids in delivery containers and in electrical equipment such as power and instrument transformers, reactors, bushings, oil-filled cables, oil-filled tank-type capacitors, switchgear and load tap changers. The main changes with respect to the previous edition are as follows: - withdrawal of askarels; - addition of…

IEC 60567:2011 deals with the techniques for sampling free gases from gas-collecting relays from power transformers. Three methods of sampling free gases are described. The techniques described take account, on the one hand, of the problems peculiar to analyses associated with acceptance testing in the factory, where gas contents of oil are generally very low and, on the other hand, of the…

ISO/TR 12705:2011 describes a laboratory method, using a printability tester, for the preparation of specimens in order to evaluate the tendency of a particular ink, substrate and printing procedure to produce chemical ghosting in sheet-fed offset lithography on coated papers or foils. A test procedure to induce ghosting using these specimens is also included. This method applies only to…

IEC 60534-8-2:2011 includes the method for measuring the sound pressure level due to liquid flow through a control valve and the method for determining the characteristic increase of noise due to the onset of cavitation. It also defines the equipment, methods and procedures for the laboratory measurement of the airborne sound needed to determine these characteristics. Two methods are provided for…