Rechercher

IEC 60695-7-3:2011 concerns laboratory tests used to measure the toxic components of the fire effluent from either electrotechnical products or materials used in electrotechnical products. It provides guidance on the use and interpretation of results from such tests. It discusses currently available approaches to toxic hazard assessment consistent with the approach of ISO TC 92 SC 3, as set out…

ISO 5600:2011 specifies a method for the determination of the static vulcanized adhesion strength of rubber compounds to rigid materials. The test piece is composed of two conical ends of the rigid material, joined by a cylinder of rubber. The adhesion is obtained by a bonding system which can include not only the rigid material and the rubber compound, but other elements such as thin alloy…

ISO 5603:2011 specifies two methods for determining the adhesion strength of vulcanized rubber to wire cord which is embedded in the rubber. The two methods do not necessarily give the same results. They are applicable primarily to test pieces prepared in the laboratory under standard conditions and used for the development and control of materials and processes utilized in the manufacture of…

ISO 10640:2011 provides a methodology to assess the ageing of polymeric systems during exposure to laboratory accelerated weathering as well as in outdoor exposures. This methodology applies mainly to photoageing, but it can also be applied to thermal ageing. The methodology identifies analyses that follow the chemical changes which control the deterioration of physical properties of materials…

ISO 6272-2:2011 describes a method for evaluating the resistance of a dry film of paint, varnish or related product to cracking or peeling from a substrate when it is subjected to a deformation caused by a falling weight, dropped under standard conditions, acting on a small-area spherical indenter. NOTE The terms "impact" and "impact resistance" are used in the title…

ISO 1853:2011 specifies the requirements for the laboratory testing of the volume resistivity of specially prepared test pieces of vulcanized or thermoplastic rubber compounds rendered conducting or dissipative by the inclusion of carbon black or ionizable materials. The tests are suitable for materials with a resistivity of less than about 108 ohm metres. Method 1 is the preferred method when…

ISO 16063-41:2011 specifies the instrumentation and procedures for performing primary and secondary calibrations of rectilinear laser vibrometers in the frequency range typically between 0,4 Hz and 50 kHz. It specifies the calibration of laser vibrometer standards designated for the calibration of either laser vibrometers or mechanical vibration transducers in accredited or non-accredited…

ISO 11990-1:2011 specifies a method of testing the continuous wave (cw) resistance of the shaft of a tracheal tube designed to resist ignition by a laser. It is not applicable to other components of the system, such as the inflation system and cuff, which are defined in ISO 11990-2:2010. ISO 11990-1:2011 can be used to measure and describe the properties of materials, products or assemblies in…

ISO 27667:2011 defines the methods for testing and assessing the corrosion effects on painted backing plates used on disc brakes and painted brake shoes used on drum brakes. The methods and assessment criteria indicated in ISO 27667:2011 are part of the specification/validation phases of the product and the series production monitoring from ISO 15484. The test procedures indicated include only…