Rechercher

This International Standard specifies the minimum requirements for billing of all consumption-based utility network services to domestic customers. It covers the processes required to produce the bill and to deal with issues that arise after the bill has been sent, as well as the content of the billing document or statement. This International Standard is applicable to utility network services…

ISO 14486:2012 specifies the characteristics of laminate floor coverings, supplied in either tile or plank form. To encourage the consumer to make an informed choice, the standard includes a classification system (see ISO 10874) based on intensity of use, which shows where these floor coverings should give satisfactory service. It also specifies requirements for marking.

1 Scope This part of IEC 61000 deals with emission of disturbances due to voltage fluctuations and flicker. The recommendations in this Technical Specification are applicable to electrical and electronic equipment that has a rated input current exceeding 75 A per phase and is intended to be connected to a public low-voltage a.c. distribution system. Recommendations that specify information…

IEC 61439-6:2012 lays down the definitions and states the service conditions, construction requirements, technical characteristics and verification requirements for low voltage BTS (see 3.101) as follows: - BTS for which the rated voltage does not exceed 1 000 V in case of a.c. or 1 500 V in case of d.c.; - BTS intended for use in connection with the generation, transmission, distribution and…

IEC 60862-2:2012 gives practical guidance on the use of SAW filters which are used in telecommunications, measuring equipment, radar systems and consumer products. IEC 60862-1 should be referred to for general information, standard values and test conditions. This part of IEC 60862 includes various kinds of filter configuration, of which the operating frequency range is from approximately 10 MHz…

ISO 24598:2012 specifies requirements for classification of solid wire electrodes, tubular cored electrodes and electrode/flux combinations (all-weld metal deposits) for submerged arc welding of creep resisting and low-alloy elevated-temperature steels. One electrode can be tested and classified with different fluxes. The solid wire electrode is also classified separately based on its chemical…

ISO 21952:2012 specifies requirements for classification of wire electrodes, wires and rods for gas shielded metal arc welding and tungsten inert-gas welding of creep-resisting steels, and for their deposits in the as-welded or post-weld heat-treated condition. One wire electrode can be tested and classified with different shielding gases. ISO 21952:2012 is a combined specification providing for…

ISO 16834:2012 specifies requirements for classification of wire electrodes, wires, rods and all-weld metal deposits in the as-welded condition and in the post-weld heat-treated (PWHT) condition for gas shielded metal arc welding and tungsten inert-gas welding of high-strength steels with a minimum yield strength greater than 500 MPa, or a minimum tensile strength greater than 570 MPa. One wire…

ISO/IEC 15944-8:2012 has been developed to support modelling generic international requirements for identifying and providing privacy protection of personal information throughout any kind of information and communications technology (ICT) based business transaction where the individual has the role of a buyer. It provides users and designers with a methodology and tools addressing requirements…

ISO/IEC 15944-8:2012 has been developed to support modelling generic international requirements for identifying and providing privacy protection of personal information throughout any kind of information and communications technology (ICT) based business transaction where the individual has the role of a buyer. It provides users and designers with a methodology and tools addressing requirements…