Electrical accessories - Portable residual current devices without integral overcurrent protection f...
Applies to portable devices consisting of a plug, a residual current device (RCD) and one or more socket-outlets or a provision for connection. They do not incorporate overcurrent protection. They are intended for single-phase circuits for rated currents not exceeding 16 A for rated voltages not exceeding 250 V a.c., or for rated current not exceeding 32 A for rated voltages not exceeding 130 V a…
Solderless connections - Part 6: Insulation piercing connections - General requirements, test method...
Determines the suitability of insulation piercing connections under specified mechanical, electrical and atmospheric conditions, and provides a means of comparing test results when the tools used to make the connections are of different design.
The document specifies the functional architecture of MAPLE, a Manufacturing Automation Programming Environment. MAPLE is a vendor-independent neutral facility for the programming of multiple manufacturing devices and controls. For the programming of manufacturing devices and controls the following areas will be supported: Connection between various manufacturing data and manufacturing…
Solderless connections - Part 1: Wrapped connections - General requirements, test methods and practi...
Determines the suitability of wrapped connections under specified mechanical, electrical and atmospheric conditions, and provides a means of comparing test results when the tools used to make the connections are of different design. The contents of the corrigendum of October 1998 have been included in this copy.
1.1 SCOPE
1.1.1 This standard applies to newly produced gas appliance connectors,
constructed entirely of new unused parts and materials, having nominal
internal diameters of ¼, 3/8, ½, 5/8, and 1 inch, and having fittings
at both ends provided with taper pipe threads for connection to a gas
appliance and to house piping. This standard covers assembled…
Manually Operated Gas Valves for Appliances, Appliance Connector Valves and
Hose End Valves
1.1 SCOPE
1.1.1 This standard applies to manually-operated gas valves (see Part IV,
Definitions), hereinafter referred to as valves, not exceeding 4 inches
(102 mm) pipe size, and pilot shut-off devices (see Part IV,
Definitions), hereinafter referred to as devices. Except for hose end
valves not intended for permanent connection to a hose, and appliance…
Electromagnetic compatibility (EMC) - Part 6: Generic standards - Section 1: Immunity for residentia...
Defines the immunity test requirements in relation to continous and transient, conducted and radiated disturbances, including electrostatic discharges, for electrical and electronic apparatus intended for use in residential, commercial and light-industrial environment, and for which no dedicated product or product-family standard exists. Immunity requirements in the frequency range 0 kHz to 400…
Flexible Insulating Sleeving - Part 2: Methods of Test
Gives methods of test for flexible insulating sleeving, including heat shrinkable sleeving intended primarily for insulating electrical conductors and connections of electrical apparatus.
