Information technology — Small computer system interface (SCSI) — Part 232: Serial Bus Protocol 2 (S...
This part of ISO/IEC 14776 defines a protocol for the transport of commands and data over
High Performance Serial Bus. The transport protocol, Serial Bus Protocol 2 or SBP-2, requires
implementations to conform to the requirements of this standard as well as to
ISO/IEC 13213:1994 and permits the exchange of commands, data and status between
initiators and targets connected to Serial Bus.
Pneumatic fluid power — Connections — Ports and stud ends
This International Standard specifies dimensions and performance requirements for ports and stud ends with
parallel threads for pneumatic fluid power applications.
It specifies reusable, positively retained seals for leak-free connections, for use at pressures from ? 0,09 MPa
(? 0,9 bar 1)) up to 1,6 MPa (16 bar).
Only this International Standard is applicable for threaded ports and stud ends…
Railway applications - Electric equipment for rolling stock - Part 3: Electrotechnical components - ...
In addition to the general requirements of IEC 60077-2, it gives the rules for circuit-breakers, the main contacts of which are to be connected to d.c. power and/or auxiliary circuits. The nominal voltage of these circuits does not exceed 3 000 V d.c. according to IEC 60850.
Applications ferroviaires - Equipements électriques du matériel roulant - Partie 3: Composants élect...
Donne en complément des règles générales de la CEI 60077-2, les règles relatives aux disjoncteurs dont les contacts sont destinés à être connectés aux circuits à courant continu de traction et/ou aux circuits des auxiliaires. La tension continue nominale de ces circuits nexcède pas 3 000 V conformément à la CEI 60850.
Wind turbine generator systems - Part 21: Measurement and assessment of power quality characteri...
Describes measurement procedures for quantifying the power quality of a grid connected wind turbine and the procedures for assessing compliance with power quality requirements.
Road vehicles — Four-pole electrical connectors with pins and twist lock — Part 2: Tests and require...
This part of ISO 15170 specifies tests and requirements for electrical connectors and connections with up to four
poles and twist lock coupling.
This type of connection is intended for electrical connections in truck, bus and trailer applications (e.g. for
components directly mounted on the engine).
Audio, video and similar electronic apparatus - Safety requirements
Applies to receiving apparatus for sound or vision, amplifiers, load and source transducers, motor-driven apparatus (radio-gramophones, tape recorders and sound-film projectors, etc.) which are to be connected to the mains, directly or indirectly, and which are intended for domestic and similar indoor use. Gives a safety and classification terminology based on IEC 60536. Specifies requirements…
Appareils audio, vidéo et appareils électroniques analogues - Exigences de sécurité
S'applique aux matériels comme les récepteurs de radiodiffusion sonore et visuelle, les amplificateurs, les transducteurs de charge et de source et ses appareils à entraînement par moteur (radio-électrophones, magnétophones et projecteurs de films sonores) qui doivent être raccordés au réseau directement ou indirectement et qui sont destinés à des usages domestiques en intérieur ou à des…
Vacuum Cleaners, Blower Cleaners and Household Floor Finishing Machines
1 Scope
1.1 This Standard applies to motor-operated vacuum cleaners and blower
cleaners, and to household use floor finishing machines to be employed in
accordance with the Canadian Electrical Code Part I (CEC), and the National
Electrical Code (NEC), ANSI/NFPA 70.
1.2 These requirements cover:
a) household, commercial, and coin-operated vacuum cleaning machines and blower…
