Rechercher

This National Standard of Canada is based on International Standard CEI/IEC 60974-5:2002 (first edition, 2002-02). 1 Scope This part of IEC 60974 specifies safety and performance requirements for industrial and professional equipment used in arc welding and allied processes to feed filler wire. The wire feeder may be a stand-alone unit which may be connected to a separate welding power…

Z241.0-03 Definitions and General Safety Requirements for Park Model Trailers 1. Scope This Standard provides the definition of the term "park model trailer" as used in the CSA Z241 Series. It also gives general safety requirements that apply to the other Standards in this Series. Z241.1-03 Vehicular Requirements for Park Model Trailers 1. Scope 1.1 Requirement Specification…

Establishes preferred measurement principles and practices to assure that meaningful data describing the optical loss performance of installed cable plants can be obtained.It is not intended for component testing, it does not define those elements of an installation that need to be measured. This procedure is a specific test associated with IEC 61281-1. This procedure can be used to measure the…

ISO 15636:2003 specifies the design and dimensions of back-up pads intended for the fixing or clamping of vulcanized fibre discs in accordance with ISO 16057, or comparable grinding tools on hand-held grinding machines, e.g. angle grinders. The connecting dimensions of support discs and clamping units are matched for spindle ends with the common practice of this kind of hand-held machine.

This National Standard of Canada is equivalent to International Standard ISO 17510-2:2003 (first edition, 2003-01-15). 1 Scope This part of the European Standard specifies requirements for masks and accessories which are required to connect the patient connection port to a sleep apnoea breathing therapy device and the mask to a patient, and are used for the application of sleep apnoea…

This National Standard of Canada is equivalent to International Standard CEI/IEC 61000-4-7:2002 (second edition, 2002-08). 1 Scope This part of IEC 61000 is applicable to instrumentation intended for measuring spectral components in the frequency range up to 9 kHz which are superimposed on the fundamental of the power supply systems at 50 Hz and 60 Hz. For practical considerations, this…

ISO 15142-3:2003 specifies metallic medical devices used for the temporary intramedullary stabilization of long bones by surgical implantation, classifying and giving other requirements and dimensions for the devices used to insert, remove or both insert and remove intramedullary nails. It also provides a means of measuring reamer diameter. It is applicable to all metal intramedullary fixation…

applies to the use of electronic equipment (EE) in power installations where a uniform technical level with respect to safety and reliability is necessary. also applies to EE which are not covered by a specific product standard. it defines the minimum requirements for the design and manufacture of EE connected to low-voltage (not exceeding 1 000 V a.c. or 1 500 V d.c.) mains supplies, for…

applies to electrical equipment, regardless of voltage, containing an insulation system, which is - connected to an electronic power supply, and - requires an evaluation of insulation endurance under repetitive voltage impulses. This standard proposes a general test procedure to facilitate screening of electrical insulation systems (EIS) and to achieve a relative evaluation of insulation…

S'applique au matériel électrique, indépendamment de la tension, comprenant un système d'isolation - connecté à une alimentation électronique, et - nécessitant une évaluation de l'endurance de l'isolation soumise à des impulsions de tension appliquées périodiquement. Cette norme propose une procédure générale d'essai afin de faciliter la sélection des systèmes d'…