Rechercher

Preface This is the first edition of AAMA/WDMA/CSA 101/I.S.2/A440-05, Standard/Specification for windows, doors, and unit skylights, jointly published by the American Architectural Manufacturers Association (AAMA), the Window & Door Manufacturers Association (WDMA), and the Canadian Standards Association (CSA). 1 Scope 1.1 General This fenestration Standard/Specification applies to both…

1 Scope 1.1 This Standard applies to the design of aluminum alloy members and assemblies intended to carry a known load. 1.2 This Standard specifies requirements for the design of members to meet the requirements of the National Building Code of Canada using limit states design procedures. 1.3 This Standard contains rules to determine the ultimate resistance of aluminum members and connections…

1 Scope 1.1 The requirements for heating and cooling equipment apply to the following stationary equipment for use in non-hazardous locations rated 7200 V or less, single- or 3-phase, and remote control assemblies for such equipment: (a) heat pumps for heating and cooling with or without factory- or field-installed electric resistance heaters, or hot water or steam heating coils; (b) air…

1 Scope 1.1 Purpose The purpose of this Standard is to minimize the risk of personal injury by providing minimum requirements for the design, construction, installation, inspection, and maintenance of the mechanical refrigeration systems specified in Clauses 1.2.1 and 1.2.2. Note: This Standard does not directly address protection of property and preservation of the environment. 1.2…

Scope 1.1.1 This Standard covers CGA 791 (Type I) and CGA 810 (Type II) cylinder connection devices, as defined in Part IV, Definitions, intended to connect the cylinder valve on portable LP-Gas containers to the inlet of the regulator on outdoor cooking gas appliances. These cylinder connection devices are intended for vapour withdrawal service only. 1.1.2 The cylinder connection devices…

1 Scope 1.1 General This Standard specifies requirements for the performance, design, testing, marking, and instructions of energy absorbers and lanyards, including lineman's pole straps and integrally connected lanyards and energy absorbers. 1.2 Applications Energy absorbers and lanyards are used as parts of complete fall arrest, travel restraint, fall restrict, or work positioning…

applies to electrical and electronic apparatus intended for use in industrial environments, as described below. Immunity requirements in the frequency range 0 Hz to 400 GHz are covered. No tests need to be performed at frequencies where no requirements are specified. This generic EMC immunity standard is applicable if no relevant dedicated product or product-family EMC immunity standard exists…

Applies to two-pole non-reversible appliance couplers for cold conditions for a.c. only, with a degree of protection against ingress of water higher than IPX0, with a rated voltage not exceeding 250 V and rated current not exceeding 10 A for a 50 Hz or 60 Hz supply. They are intended for the connection of the supply cord to portable electrical appliances of class II for household, commercial and…

1. SCOPE 1.1 This Standard applies to exhaust cleaning assemblies intended primarily for use with exhaust systems for commercial and institutional type cooking equipment such as ranges, broilers, deep fat fryers, grills, etc, that are Gas-Fuelled and Electronically-Fuelled. They are complete units typically including filter box, filters, odour removal media, fire damper, fan box, fan and…

ISO/TS 10303-1251:2004 specifies the application module for Interface. The following are within the scope of ISO/TS 10303-1251:2004: the identification of the interface specification; the identification of a version of an interface…