Rechercher

IEC 60384-19:2006 is applicable to fixed surface mount capacitors for direct current, with metallized electrodes and polyethylene-terephthalate dielectric for use in electronic equipment. These capacitors have metallized connecting pads or soldering strips and are intended to be mounted direct onto substrates for hybrid circuits or onto printed boards. These capacitors may have "self-healing…

Provides the general principles to be followed in the protection against lightning of - structures including their installations and contents as well as persons, - services connected to a structure. The following cases are outside the scope of this standard: - railway systems; - vehicles, ships, aircraft, offshore installations; - underground high pressure pipelines; - pipe, power and…

ISO 15848-1:2005 specifies testing procedures, for evaluation of external leakage of valve stem seals (or shaft) and body joints of isolating valves and control valves intended for application in volatile air pollutants and hazardous fluids. End connection joints, vacuum application, effects of corrosion and radiation are excluded from ISO 15848-1:2005. ISO 15848-1:2005 concerns classification…

Scope This Code covers all electrical work and electrical equipment operating or intended to operate at all voltages in electrical installations for buildings, structures, and premises, including factory-built relocatable and non-relocatable structures, and self-propelled marine vessels stationary for periods exceeding five months and connected to a shore supply of electricity continuously or…

This National Standard of Canada is equivalent to International Standard IEC 60601-2-17:04, second edition. 1 Scope and object This clause of the General Standard applies except as follows: 1.1 Scope Addition: 1.1.101 This Particular Standard specifies requirements for the safety of automaticallycontrolled EQUIPMENT for BRACHYTHERAPY of patients using AFTERLOADING techniques. 1.1.102 This…

ISO 7240-1:2005 provides a set of general guidelines and definitions to be used in describing the fire detection and alarm system equipment, tests and requirements in the other parts of ISO 7240. The components that a fire detection and alarm system can have are shown in Figure 1. Item C of Figure 1 can be replaced by a sound system for emergency purposes, the components of which are shown in…

Specifies a procedure for measuring the power performance characteristics of a single wind turbine and applies to the testing of wind turbines of all types and sizes connected to the electrical power network. Also describes a procedure to be used to determine the power performance characteristics of small wind turbines (as defined in IEC 61400-2) when connected to either the electric power…

Applies to receiving apparatus for sound or vision, amplifiers, load and source transducers, motor-driven apparatus (radio-gramophones, tape recorders and sound-film projectors, etc.) which are to be connected to the mains, directly or indirectly, and which are intended for domestic and similar indoor use. Gives a safety and classification terminology based on IEC 60536. Specifies requirements…

S'applique aux matériels comme les récepteurs de radiodiffusion sonore et visuelle, les amplificateurs, les transducteurs de charge et de source et ses appareils à entraînement par moteur (radio-électrophones, magnétophones et projecteurs de films sonores) qui doivent être raccordés au réseau directement ou indirectement et qui sont destinés à des usages domestiques en intérieur ou à des…

ISO 16070:2005 provides the requirements for lock mandrels and landing nipples within the production/injection conduit for the installation of flow control or other equipment used in the petroleum and natural gas industries. ISO 16070:2005 includes the interface connections to the flow control or other equipment, but does not cover the connections to the well conduit.