Fixed inductors for electromagnetic interference suppression - Part 2: Sectional specification
Applies to fixed conductors designed for electromagnetic interference suppression and which fall within the scope of the generic spedification, IEC 60938-1. It is restricted to fixed inductors for which safety tests are appropriate. This implies that inductors specified according to this specification will either be connected to mains supplies, when compliance with the mandatory test of table 1…
Electricity metering - Data exchange for meter reading, tariff and load control - Part 47: COSEM tra...
Specifies the transport layers for COSEM communication profiles for use on IPv4 networks. These communication profiles contain a connection-less and a connection-oriented transport layer, providing OSI-style services to the service user COSEM application layer. The connection-less transport layer is based on the Internet standard User Datagram Protocol. The connection-oriented transport layer is…
High-voltage switchgear and controlgear - Part 300: Seismic qualification of alternating current cir...
This technical report applies only to circuit-breakers with their supporting structures which are rigidly connected with the ground, and does not cover the seismic qualification of circuit-breakers in metal enclosed switchgear.
Fuel cell road vehicles — Safety specifications — Part 3: Protection of persons against electric sho...
ISO 23273-3:2006 specifies the essential requirements of fuel cell vehicles (FCV) for the protection of persons and the environment inside and outside the vehicles against electric shock.
It applies only to on-board electric circuits with working voltages between 25 V a.c. and 1000 V a.c., or 60 V d.c. and 1500 V d.c. respectively.
ISO 23273-3:2006 does not apply to:
FCV connected to an external…
Fibre optic interconnecting devices and passive components - Basic test and measurement procedures -...
Optical fibre connectors for polarization maintaining fibre (PMF) shall align the birefringence axes of the two mating fibres. The keying accuracy of PM connector plugs should be specified to realize PMF connection with high extinction ratio propagation. This part of IEC 61300 provides a method to measure the keying accuracy of a polarization maintaining fibre connector.
Aircraft — Ground service connections — Locations and types
ISO 10842:2006 specifies the locations and types of aircraft ground service connections in order to optimize ground services, both fixed and mobile, for the following seven services:
400 Hz electrical power;preconditioned air for cabin conditioning;pneumatic power for jet engine start;potable water;lavatory service (draining, flushing);aircraft refuelling;interphone (headset) connections.
It…
Recommendations for small renewable energy and hybrid systems for rural electrification - Part 9-3: ...
Specifies the general requirements for the design and the implementation of the interface equipment within the user's installation which connects to a microgrid or the generating part of a standalone system.
Technical aids for persons with disability — Environmental control systems for daily living
ISO 16201:2006 specifies functional and technical requirements and test methods for environmental control systems intended for use to alleviate or compensate for a disability. Such systems are also known as electronic aids to daily living.
The aim of ISO 16201:2006 is to provide safety requirements and recommendations for manufacturers of such environmental control systems.
Target devices are not…
Road vehicles — Implementation of WWH-OBD communication requirements — Part 4: Connection between ve...
ISO/PAS 27145-4:2006 defines the requirements to successfully establish, maintain and terminate communication with a vehicle that implements the requirements of the WWH-OBD global technical regulation. This requires plug and play communication capabilities of the vehicle, as well as any test equipment that intends to establish communication with a vehicle. ISO/PAS 27145-4:2006 details all the OSI…
