Rechercher

ISO/TS 10303-1704:2006 specifies the application module for Network functional design view. The following are within the scope of ISO/TS 10303-1704:2006: the identification of a functional unit;the identification and representation of a network of functional units;the identification and representation of connections…

Applies to all electronic equipment for control, regulation, protection, supply etc. associated with the accumulator battery of the vehicle or a low voltage power supply source with or without the direct connection to the contact system. Does not apply however to electronic power circuits which conform to IEC 61287-1. It covers the conditions of operation, design, construction and testing of…

This part of IEC 60947 applies to flow rate switches that sense the rate of flow of a gas, a liquid or a granular solid. These switches change their output state if a pre-set value for the speed of flow is exceeded. These flow rate switches are self-contained, have semiconductor switching element(s) and are intended to be connected to circuits, the rated voltage of which does not exceed 250 V 50…

La présente partie de la CEI 60947 s'applique aux détecteurs de débit qui détectent la vitesse d'écoulement d'un gaz, d'un liquide ou de matière solide granulaire. Ces détecteurs changent l'état de leur sortie si une valeur préréglée du débit est dépassée. Ces détecteurs de débit sont des appareils complets, comprennent des éléments de commutation à semiconducteurs et…

This National Standard of Canada is equivalent to International Standard ISO/IEC 14165-114:2005. 1 Scope This International Standard describes a physical interface for Fibre Channel that is based on and adds to ISO/IEC 14165-115. It specifies a Medium Dependent Interface for 1000BASETX2/4 PHY layers as defined in ISO/IEC 7498-1 together with the consequences for the physical layer and the…

This National Standard of Canada is equivalent to International Standard ISO/IEC 14165-115:2006. 1 Scope This part of ISO/IEC 14165 describes the physical interface portions of a high performance serial link that supports the higher Upper Level Protocols (ULPs) associated with HIPPI, IPI, SCSI, IP and others. This International Standard incorporates features described in other…

This National Standard of Canada is equivalent to International Standard ISO/IEC 14165-116:2005. 1 Scope This part of ISO/IEC 14165 describes the signalling and physical requirements that may be utilized by Fibre Channel-2 (FC-2) level transport data at a rate in excess of 10 Gbit/s.

This National Standard of Canada is equivalent to International Standard ISO/IEC 14165-122:2005. 1 Scope This part of ISO/IEC 14165 specifies signaling interface enhancements for FC-PH, to allow L_Ports to operate with an Arbitrated Loop topology. This standard defines L_Ports that retain the functionality of Ports as specified in FC-PH. The Arbitrated loop topology attaches multiple…

This National Standard of canada is equivalet to International Standard ISO/IEC 14165-222:2005. 1 Scope This part of ISO/IEC 14165 describes a communication interface between a channel and I/O control units that utilize the Single-Byte Command Code Sets (SBCCS) as implemented in a wide range of data processing systems. It employs information formats and signalling protocols that provide a…

This National Standard of Canada is equivalent to International Standard ISO/IEC 14165-241:2005. 1 Scope This part of ISO/IEC 14165 defines mappings for transporting Fibre Channel frames across ATM, SONET and TCP/IP backbone networks. This part of ISO/IEC 14165 consists of three distinct Fibre Channel mappings resulting in the following three specifications: - FC-BB-2_ATM (FC over ATM…