Household Electrical Appliances - Measurement of Standby Power
This National Standard of Canada is based on International Standard CEI/IEC 62301:2005.
1 Scope
This International Standard specifies methods of measurement of electrical power consumption in standby mode. It is applicable to mains powered electrical household appliances and to the mains powered parts of appliances that use other fuels such as gas or oil.
This standard does not specify…
Appareils électrodomestiques - Mesure de la consommation en veille
La présente norme nationale du Canada est basee sur la norme internationale CEI/IEC 62301:2005.
1 Domaine d'application
La présente Norme internationale spécifie les méthodes de mesure de la consommation électrique en mode veille. Elle s'applique aux appareils électrodomestiques connectés au réseau et aux parties d'appareils connectées au réseau qui utilisent d'autres…
1 Scope
1.1
This Standard applies to extra-low-voltage landscape lighting systems and associated components that are
intended for cord-connected, direct plug-in, or permanent connection to a branch circuit of not more
than 150 volts-to-ground in accordance with the Canadian Electrical Code, Part I.
1.2
This Standard only covers extra-low-voltage landscape lighting systems where the…
1.1 Scope
1.1.1
This Standard applies to newly produced gas-fired outdoor infrared patio heaters (See Part IV, Definitions) hereinafter referred to as heaters or appliances, constructed entirely of new, unused parts and materials.
Patio heaters are:
a. For use with natural gas; and
b. For use with liquefied petroleum (propane) gases.
1.1.2
The heaters covered by this Standard are intended for…
Press-Connect Copper and Copper Alloy Fittings for Use in Fuel Gas Distribution Systems
1.1 Scope
1.1.1
This standard applies to copper and copper alloy press-connect type fittings, and valves (hereafter referred to as fittings unless otherwise specified) for use with fuel gas tube systems intended for installation above ground, below ground, indoors and outdoors.
1.1.2
This standard applies to tube systems rated for operating pressures not exceeding 125 psi (862 kPa).
1.1.3
This…
Nuclear fuel technology — Tank calibration and volume determination for nuclear materials accountanc...
ISO 18213-2:2007 presents procedures for standardizing a set of calibration data to a fixed set of reference conditions so as to minimize the effect of variations in ambient conditions that occur during the measurement process. The procedures presented herein apply generally to measurements of liquid height and volume obtained for the purpose of calibrating a tank (i.e., calibrating a tank's…
Gas welding equipment — Rubber and plastics hose and hose assemblies for use with industrial gases u...
ISO 14113:2007 specifies requirements for rubber and plastics hose and hose assemblies for use with compressed, liquefied and dissolved gases up to a maximum working pressure of 45 MPa (450 bar), within the ambient temperature range of - 20 °C to + 60 °C.
ISO 14113:2007 applies to hose assemblies used to connect industrial gas cylinders to manifolds or bundles prior to any pressure reduction…
Machine tools — Connecting dimensions of spindle noses and work holding chucks — Part 2: Camlock typ...
ISO 702-2:2007 specifies the sizes for interchangeability of cylindrical spindle noses and corresponding connecting faces of face plates or work holding chucks.
Space data and information transfer systems — Proximity-1 space link protocol — Physical layer
ISO 21460:2007 defines the Proximity-1 space link protocol physical layer. It specifies the channel connection process, provision for frequency bands and assignments, hailing channel, polarization, modulation, data rates, and performance requirements. Currently, the physical layer only defines operations at UHF frequencies for the Mars environment. The coding layer is defined in ISO 21459. The…
