Rechercher

L'ISO 16061:2008 spécifie les exigences générales relatives aux instruments à utiliser en association avec les implants chirurgicaux non actifs. Ces exigences s'appliquent aux instruments fournis après fabrication ou aux instruments refournis après remise en état. L'ISO 16061:2008 s'applique également aux instruments pouvant être connectés à des systèmes motorisés mais elle ne…

ISO/TR 11044:2008 discusses scientific and technical aspects that have been considered in connection with the development of batch algal growth inhibition test procedures specified in ISO 8692, for freshwater, and ISO 10253, for marine waters. Previously unpublished results of experiments performed at the Norwegian Institute for Water Research (NIVA) have been included to demonstrate various…

IEC 61643-12:2008 describes the principles for selection, operation, location and coordination of SPDs to be connected to 50 Hz to 60 Hz a.c. and to d.c. power circuits and equipment rated up to 1 000 V r.m.s. or 1 500 V d.c. Specific change with respect to the previous edition is the incorporation of Amendment 1, which was not published separately due to the number of changes and pages.

La CEI 61643-12:2008 décrit les principes relatifs au choix, à la mise en uvre, à l'emplacement et à la coordination des parafoudres à connecter sur des circuits de puissance 50 Hz à 60 Hz en courant alternatif et des circuits en courant continu, et des matériels de puissance allant jusqu'à 1 000 V en valeur efficace ou 1 500 V en courant continu. Le changement spécifique par rapport à…

Gives guidance on the short-circuit maximum temperature limits of electric cables having rated voltages of 1 kV (Um = 1,2 kV) and 3 kV (Um = 3,6 kV), with regard to the following: - insulating materials; - oversheath and bedding materials; - conductor and metallic sheath materials and methods of connection. The design and accessories and the influence of the installation conditions on the…

Gives guidance on the short-circuit maximum temperature limits of electric cables having rated voltages from 6 kV (Um = 7,2 kV) up to 30 kV (Um = 36 kV), with regard to the following: - insulating materials; - oversheath and bedding materials; - conductor and metallic sheath materials and methods of connection. The design of accessories and the influence of the installation conditions on the…

Gives guidance on the short-circuit maximum temperature limits of electric cables having rated voltages above 30 kV (Um = 36 kV) up to the voltage limits given in IEC 60141 and IEC 60840, with regard to the following: - insulating materials; - oversheath and bedding materials; - conductor and metallic sheath materials and methods of connection. The design of accessories and the influence of…

IEC 61156-3:2008(E) defines individually screened, common overall core screen and unscreened pairs or quads in cables for work area wiring. These cables are suitable for the various communication systems for which the reference is given in the relevant detail specification. The cables covered by this sectional specification are intended to operate with voltages and currents normally adopted for…

ISO/TS 19072-3:2008 defines the general minimum specifications of a type 1 three-way connection interface, including ground connection, linking the pyrotechnic device and harness connector built into a road vehicle. A two-way without ground variant of the pyrotechnic device/initiator harness connector assembly is also defined. All requirements apply also to the two-way design, excepted all items…