Rechercher

IEC 61918:2010 specifies basic requirements for the installation of media for communication networks in industrial premises and within and between the automation islands, of industrial sites. It covers balanced and optical fibre cabling and the cabling infrastructure for wireless media, but not the wireless media itself. Additional media are covered in the IEC 61784-5 series. It also covers: -…

Preface This is the second edition of CSA C827, Energy performance of food service refrigerators and freezers. It supersedes the first edition, published in 1998. Scope 1.1 This Standard applies to commercial refrigerator, refrigerator-freezer, and freezer cabinets that are intended for storing or holding food products and other perishable merchandise. 1.2 This Standard specifies…

IEC 60512-21-1:2010 when required by the detail specification, is used for testing connectors within the scope of technical committee 48. It may also be used for similar devices when specified in a detail specification. The object of this standard is to detail a standard test method to determine the value of RF shunt resistance which degrades the quality factor of an L/C circuit when a connector…

ISO/TS 17575‑2:2010 defines how to convey all or parts of the data element structure defined in ISO/TS 17575‑1 over any communication stack and media suitable for this application. It is focussed on mobile communication links. However, wired links shall use the same methodology. The communication interface shall be implemented as an API in the programming environment of choice for the Front End (…

IEC 61010-2-030:2010 specifies safety requirements for testing and measuring circuits which are connected for test or measurement purposes to devices or circuits outside the measurement equipment itself. These include measurement circuits which are part of electrical test and measurement equipment, laboratory equipment, or process control equipment. The existence of these circuits in equipment…

ISO/IEC 29157:2010 specifies the physical layer (PHY) characteristics and medium access control (MAC) procedures used for short-range, low-data-rate, wireless communications with very low latency and point-to-multipoint connection capability in the industrial, scientific and medical (ISM) band.

ISO/IEC 29157:2010 specifies the physical layer (PHY) characteristics and medium access control (MAC) procedures used for short-range, low-data-rate, wireless communications with very low latency and point-to-multipoint connection capability in the industrial, scientific and medical (ISM) band.

ISO 12151-1:2010 specifies the general and dimensional requirements for the design and performance of hose fittings with O-ring face seal ends in accordance with ISO 8434-3, made of carbon steel, for nominal hose inside diameters of 6,3 mm to 38 mm inclusive, in accordance with ISO 4397. Materials other than carbon steel can be supplied as agreed between the manufacturer and user. These hose…

ISO 12151-3:2010 specifies the general and dimensional requirements for the design and performance of flange hose fittings, made of carbon steel, for nominal hose inside diameters of 12,5 mm to 51 mm inclusive, in accordance with ISO 4397, for use with ports and clamps in accordance with ISO 6162-1 and ISO 6162-2. Materials other than carbon steel can be supplied as agreed between the…

Scope 1.1 This Standard applies to electrically operated, general-purpose valves* and safety valves* that are intended to be used in ordinary locations in accordance with the Canadian Electrical Code, Part I, for the control of fluids (e.g., air, gases, oils, refrigerants, steam, water, etc.), and rated 600 V and less. *For convenience, the shorter term "valve" is used where the same…