Rechercher

ISO/IEC 29341-18-13:2011(E) describes a service definition which is compliant with the UPnP Device Architecture version 1.0. It defines a service type referred to herein as RATAConfig service. The RATAConfig service is a UPnP service that allows control points to provision and configure the parameters that are required for enabling a Remote Access Server to accept and a Remote Access Client to…

ISO/IEC 29431-18-10:2011(E) describes a service definition which is compliant with the UPnP Device Architecture version 1.0. It defines a service type referred to herein as InboundConnectionConfig service. The InboundConnectionConfig service is a UPnP service that allows control points to configure the parameters that will enable the service to test if the host device is reachable from the…

ISO/IEC 29341-18-13:2011(E) describes a service definition which is compliant with the UPnP Device Architecture version 1.0. It defines a service type referred to herein as RATAConfig service. The RATAConfig service is a UPnP service that allows control points to provision and configure the parameters that are required for enabling a Remote Access Server to accept and a Remote Access Client to…

IEC 61439-1:2011 lays down the definitions and states the service conditions, construction requirements, technical characteristics and verification requirements for low-voltage switchgear and controlgear assemblies. This standard cannot be used alone to specify an ASSEMBLY or used for a purpose of determining conformity. ASSEMBLIES shall comply with the relevant part of the IEC 61439 series;…

IEC 61439-2:2011 defines the specific requirements of power switchgear and controlgear assemblies (PSC-ASSEMBLIES) as follows: - ASSEMBLIES for which the rated voltage does not exceed 1 000 V in case of a.c. or 1 500 V in case of d.c.; - stationary or movable ASSEMBLIES with or without enclosure; - ASSEMBLIES intended for use in connection with the generation, transmission, distribution and…

ISO/IEC 80601-2-13:2011 is applicable to the basic safety and essential performance of an anaesthetic workstation for administering inhalational anaesthesia whilst continuously attended by a professional operator. ISO/IEC 80601-2-13:2011 specifies particular requirements for a complete anaesthetic workstation and the following anaesthetic workstation components which, although considered as…

IEC 60684-2:2011 gives methods of test for flexible insulating sleeving, including heat-shrinkable sleeving, intended primarily for insulating electrical conductors and connections of electrical apparatus, although they may be used for other purposes. The tests specified are designed to control the quality of the sleeving but it is recognized that they do not completely establish the suitability…

ISO/IEC 80601-2-13:2011 is applicable to the basic safety and essential performance of an anaesthetic workstation for administering inhalational anaesthesia whilst continuously attended by a professional operator. ISO/IEC 80601-2-13:2011 specifies particular requirements for a complete anaesthetic workstation and the following anaesthetic workstation components which, although considered as…

1 Scope 1.1 This Standard covers nonrecirculating toilets, vacuum toilets, and waste-holding tanks. For these products, this Standard specifies requirements for (a) design; (b) materials; (c) components; (d) construction and finish; (e) testing; (f) installation; (g) operation; and (h) markings. 1.2 This Standard covers nonrecirculating toilets and vacuum toilets that (a) are…

1.1 Scope 1.1.1 This standard applies to newly-produced, hand-operated quick-disconnect devices, hereinafter also referred to as devices, constructed entirely of new, unused parts and materials which provide a means for connecting and disconnecting appliances or appliance connectors to gas supplies and which are for indoor and outdoor applications. These devices shall be equipped with automatic…