Rechercher

IEC 60865-1:2011 is applicable to the mechanical and thermal effects of short-circuit currents. It contains procedures for the calculation of: the electromagnetic effect on rigid conductors and flexible conductors, the thermal effect on bare conductors. For cables and insulated conductors, reference is made, for example, to IEC 60949 and IEC 60986. For the electromagnetic and thermal effects in d…

IEC/TR 61000-3-14:2011(E) is a Technical Report which provides guidance on principles that can be used as the basis for determining the requirements for the connection of disturbing installations to low voltage (LV) public power systems. For the purposes of this part of IEC 61000, a disturbing installation means an installation (which may be a load or a generator) that produces disturbances:…

IEC 61148:2011 is applicable to the terminal markings for the main circuits of valve device stacks and assemblies, and of integrated conversion equipment. The terminal markings refer to stacks, assemblies and equipment comprising semiconductor valve devices. The object of this standard is to specify a logical alphanumeric marking system for the identification of the external main terminals of the…

IEC TR 61000-3-14:2011 is a Technical Report which provides guidance on principles that can be used as the basis for determining the requirements for the connection of disturbing installations to low voltage (LV) public power systems. For the purposes of this part of IEC 61000, a disturbing installation means an installation (which may be a load or a generator) that produces disturbances:…

1 Scope 1.1 These requirements apply to the following stationary equipment for use in nonhazardous locations rated 7200 V or less, single- or 3-phase, and remote control assemblies for such equipment: a) Heat pumps, for heating and cooling with or without factory, or field-installed electric resistance heaters, or hot water or steam heating coils. b) Air conditioners for cooling with or…

1 Scope 1.1 This Standard applies to single- or multiple-conductor, round, flat, or coiled appliance wiring material products classified as follows: (a) Class I — internal wiring of equipment (single- or multiple-conductor constructions with or without an insulating covering, covering or jacket): (i) Group A — not subject to mechanical abuse; and (ii) Group B — potentially subject to mechanical…

1.1 Scope 1.1.1 This standard applies to newly produced direct fired construction heaters, hereinafter referred to as heaters or appliances, constructed entirely of new, unused parts and materials and primarily intended for temporary use in heating buildings or structures under construction, alteration or repair. All the products of combustion generated by the heater are released into the area…

1.1 Scope 1.1.1 This standard applies to newly produced gas-fired unvented room heaters and gas-fired unvented decorative room heaters for connection to the house fuel supply system (see Part IV, Definitions), hereinafter referred to as room heaters or appliances, constructed entirely of new, unused parts and materials, having input ratings up to and including 40,000 Btu/hr (11 723 W) except: a…

ISO 9836:2011 deals with the definition and calculation of surface area and volume indicators. In defining area measurement, ISO 9836:2011 uses three measurement concepts: the intra-muros and extra-muros concept used in many parts of the world; the wall centre method of measurement used in many parts of the world; variations on these methods to comply with certain…

ISO 13628-15:2011 addresses recommendations for subsea structures and manifolds, within the frameworks set forth by recognized and accepted industry specifications and standards. As such, it does not supersede or eliminate any requirement imposed by any other industry specification. ISO 13628-15:2011 covers subsea manifolds and templates utilized for pressure control in both subsea production of…