Video surveillance systems for use in security applications - Part 3: Analog and digital video inter...
IEC 62676-3:2013 specifies physical, electrical and software interface (non-IP) specifications of analog and digital video interface in video surveillance systems (so far called CCTV) applications. Video interfaces are used both for connection and transmission of surveillance video, audio and control signals. This International Standard applies strictly to Video Surveillance Systems. This…
ISO 7840:2013 specifies general requirements and physical tests for fire-resistant hoses for conveying petrol or petrol blended with ethanol and diesel fuel or diesel fuel blended with FAME, designed for a working pressure not exceeding 0,34 MPa for hoses with nominal bore up to and including 10 mm and 0,25 MPa for hoses up to 63 mm inner diameter in craft of hull length up to 24 m.
It applies to…
Dentistry — Minimal dental implant data set for clinical use
ISO 16498:2013 specifies the minimal data set to be recorded for a patient receiving dental implant treatment. This will comprise the locations and types of dental implant bodies, connecting components and adjunctive devices, including grafting materials, placed in a patient's jaw(s).
Fuel cell technologies - Part 3-201: Stationary fuel cell power systems - Performance test methods f...
IEC 62282-3-201:2013 provides test methods for the electric/thermal and environmental performance of small stationary fuel cell power systems that meet the following criteria:
- output: nominal electric power output of less than 10 kW;
- output mode: grid-connected/independent operation or stand-alone operation with single-phase AC output or 3-phase AC output not exceeding 1 000 V, or DC output…
Low-voltage fuses - Part 2: Supplementary requirements for fuses for use by authorized persons (fuse...
IEC 60269-2:2013 provides supplementary requirements for fuses for use by authorized persons and are generally designed to be used in installations where the fuse-links are accessible to, and may be replaced by, authorized persons only. Fuses for use by authorized persons according to the following fuse systems also comply with the requirements of the corresponding subclauses of IEC 60269-1,…
Low-voltage switchgear and controlgear — Part 1: General rules
This standard applies, when required by the relevant product standard, to switchgear and controlgear
hereinafter referred to as ²equipment² and intended to be connected to circuits, the rated voltage of which
does not exceed 1 000 V a.c. or 1 500 V d.c.
It does not apply to low-voltage switchgear and controlgear assemblies which are dealt with in IEC 60439.
NOTE – In certain clauses or…
Scope
1.1
This standard applies to newly produced outdoor specialty gas appliances (see Clause 3), hereinafter referred to as appliances, constructed entirely of new, unused parts and materials. Appliances submitted for examination under this standard shall be classified as portable. These products are not intended for commercial use.
1.2
This standard applies to recreational vehicle grills (see…
Solderless connections - Part 2: Crimped connections - Generalrequirements, test methods and practic...
IEC 60352-2:2006+A1:2013 Determines the suitability of solderless crimped connections under specified mechanical, electrical and atmospheric conditions and provides a means of comparing test results when the tools used to make the connections are of different designs or manufacture. This consolidated version consists of the second edition (2006) and its amendment 1 (2013). Therefore, no need to…
