Rechercher

1 SCOPE 1.1 This Standard provides minimum requirements for primary containment leak detection that uses qualitative characteristics to detect leaks in the primary containment. NOTE: Depending on the design of the tank system, and the capabilities of the leak detection devices, leaks from the tank alone, and/or from other parts of the tank system, may be detected. 1.2 Nonvolumetric leak…

1 DOMAINE D’APPLICATION 1.1 La présente norme comprend les exigences minimales relatives à la détection des fuites dans une enceinte de confinement primaire. Cette détection s’appuie sur l’évaluation qualitative des caractéristiques. REMARQUE : Selon la conception du système de stockage, et les capacités des dispositifs de détection des fuites, les fuites provenant du réservoir seulement, ou…

1 Scope This part of IEC 61000 is concerned with the limitation of voltage fluctuations and flicker impressed on the public low-voltage system. It specifies limits of voltage changes which may be produced by an equipment tested under specified conditions and gives guidance on methods of assessment. This part of IEC 61000 is applicable to electrical and electronic equipment having an input…

IEC TR 62511:2014(E) provides guidelines in planning and design of the interconnected power system (IPS) and consequently achieve the delivery of reliable supply service. The guidelines for the design of interconnected power systems within this document will enhance system reliability, mitigate many of the adverse impacts associated with the loss of a major portion of the system or unintentional…

IEC 60335-2-90:2006+A1:2010+A2:2014 The safety of microwave ovens with a cavity door intended for commercial use, their rated voltage being not more than 250 V for single-phase appliances connected between one phase and neutral and 480 V for other appliances. It also deals with the safety of microwave ovens without a cavity door and with transportation means that are intended for commercial use…

IEC PAS 80005-3:2014(E) describes low voltage shore connection (LVSC) systems, on board the ship and on shore, to supply the ship with electrical power from shore. This PAS is applicable to the design, installation and testing of LVSC systems and addresses: - LV shore distribution systems; - shore-to-ship connection and interface…

ISO 17324:2014 specifies requirements of rubber hoses used in the automotive turbocharger system to connect turbocharger, intercooler, and internal combustion engine at the working temperatures from −40°C to +250°C and the working pressures from −0,01MPa(−0,1bar) to 0,5MPa(5bar). Hoses covered by ISO 17324:2014 may be straight or shaped.

ISO 6806:2014 specifies the minimum requirements for rubber hoses and hose assemblies for use in oil burners. The following two types of hose assembly are specified. Type 1: Hose assemblies for flux and reflux, but not for insertion between the oil burner pump and the atomizing connection; maximum working pressure 1,0 MPa (10 bar); maximum oil temperature 100 °C. Type 2: Hose assemblies for…

IEC 80601-2-58:2014 applies to the basic safety and essential performance of lens removal devices and vitrectomy devices for ophthalmic surgery and associated accessories that can be connected to this medical electrical equipment, hereafter referred to as ME equipment. Hazards inherent in the intended physiological function of ME equipment or ME systems within the scope of this standard are not…

IEC 62353:2014 applies to testing of medical electrical equipment and medical electrical systems, hereafter referred to as ME equipment and ME systems, or parts of such equipment or systems, which comply with IEC 60601-1:1988 (second edition) and its amendments and IEC 60601-1:2005 (third edition) and its amendments, before putting into service, during maintenance, inspection, servicing and after…