Natural gas fuelling stations — LNG stations for fuelling vehicles
ISO 16924:2016 specifies the design, construction, operation, maintenance and inspection of stations for fuelling liquefied natural gas (LNG) to vehicles, including equipment, safety and control devices.
ISO 16924:2016 also specifies the design, construction, operation, maintenance and inspection of fuelling stations for using LNG as an onsite source for fuelling CNG to vehicles (LCNG fuelling…
1.1
This Standard applies to industrial electrical machinery comprising interconnected mechanical,
electrical, or electronic industrial equipment operating in a coordinated manner.
1.2
This Standard applies to equipment rated at not more than 1000 V intended to be installed and used in
non-hazardous locations in accordance with the rules of the Canadian Electrical Code, Part I.
1.3
This…
1.1
This Standard applies to arc fault protective devices designed to be installed in accordance with the Rules of the Canadian Electrical Code, Part I.
1.2
These devices include arc fault circuit interrupters (AFCI) and devices that incorporate arc fault circuit protection for use on single phase, 120 V, or single phase, two-pole, three-wire 120/240 V alternating current, 60 Hz circuits…
This Standard applies to cord-connected, electrically heated warming pads with associated control units, for household and hospital use, to be used in nonhazardous locations, designed for nominal 120 V ac circuits, in accordance with the Canadian Electrical Code, Part I.
1.1 Purpose
This Standard establishes minimum requirements for electrical work and electrical equipment
operating, or intended to operate, at a mine.
Note: Users should be aware that federal, provincial, and territorial legislation can impose additional
requirements.
1.2 Application
This Standard is supplementary to, or amendatory of, the requirements of the Canadian Electrical Code,
Part…
1.1
This Standard describes the design, construction, load rating, installation, erection, inspection,
maintenance, repair, modification, test, and operation of lattice and telescopic boom mobile cranes.
Note: See Annex A for illustrations of mobile cranes and Annex B for illustrations of parts of a mobile crane.
1.2
This Standard applies only to machines that have all of the following…
Site preparation, foundation, and installation of buildings
1.1 Application
This Standard applies to single- and multi-section buildings supported on longitudinal floor beams, or
perimeter rim joists designed to perform as beams.
1.2 Issues addressed
This Standard specifies requirements for the following aspects of building installation:
a) site preparation;
b) permanent foundations;
c) anchorage to resist overturning and pier toppling due to wind…
Electric power connectors for use in overhead line conductors
This Standard specifies requirements for the mechanical, electrical, and environmental performance of connectors designed for installation on the bare surface of overhead line conductors at normal operating temperatures up to 100 °C.
Note: Although the requirements of this Standard were developed primarily for connections to aluminum conductors, the requirements are also applicable to connectors…
Information technology — High efficiency coding and media delivery in heterogeneous environments — P...
This part of ISO/IEC 23008-3 specifies technology which supports the efficient transmission of 3D audio
signals and flexible rendering for the playback of 3D audio in a wide variety of listening scenarios. These
include 3D home theater setups, 22.2 loudspeaker systems, automotive entertainment systems and playback
over headphones connected to a tablet or smartphone.
Information technology — UPnP Device Architecture — Part 3-10: Audio Video Device Control Protocol —...
This service definition is compliant with the UPnP Device Architecture version 1.0.
This service type enables control over the transport of audio and video streams. The service type defines a
‘common’ model for A/V transport control suitable for a generic user interface. It can be used to control a wide
variety of disc, tape and solid-state based media devices such as CD players, VCRs and MP3…