Rechercher

1.1 General This Standard details mechanical, physical, and electrical requirements for a newly manufactured appliance that dispenses natural gas for vehicles directly into the vehicle natural gas fuel storage system, referred to as a residential fueling appliance (RFA). 1.2 Application These requirements apply to appliances: a) for natural gas only (see Clause 1.1); b) for outdoor or…

1.1 This Standard applies to modular wiring systems combined with the office furniture in which they are intended to be used. 1.2 This Standard applies to equipment intended to be permanently connected to one or more supply circuits at a nominal system voltage of 120 V to ground, and a rating of 15 or 20 A maximum per circuit, for use in nonhazardous locations, in accordance with the Rules of…

1.1 This Standard applies to fuel gas piping systems using corrugated stainless steel tubing (CSST), intended for installation in residential, commercial or industrial buildings, and including the following components as a minimum: a) Corrugated stainless steel tubing (CSST); b) Fittings for connection to the CSST; and c) Striker plates (see Clause 3, Definitions) to protect the installed…

1.1 This Standard covers construction and performance requirements for control units and accessories for intrusion alarm systems, including: A Protected premises control units and accessories for local or signal receiving centre connections; and B Signal receiving centre alarm receiving equipment including recording equipment. 1.2 The equipment covered by this standard is intended for use in…

IEC 62439-2:2016 is applicable to high-availability automation networks based on the ISO/IEC/IEEE 8802-3 (IEEE 802.3) (Ethernet) technology. This part of the IEC 62439 series specifies a recovery protocol based on a ring topology, designed to react deterministically on a single failure of an inter-switch link or switch in the network, under the control of a dedicated media redundancy manager node…

IEC 62439-2:2016 concerne les réseaux de haute disponibilité pour l'automation reposant sur la technologie ISO/IEC/IEEE 8802-3 (IEEE 802.3) (Ethernet). La présente partie de la série IEC 62439 spécifie un protocole de reprise reposant sur une topologie en anneau, conçu pour réagir de manière déterministe sur une seule défaillance d'une maille interétage ou d'un commutateur du…

IEC 62439-5:2016 is applicable to high-availability automation networks based on the ISO/IEC/IEEE 8802-3 (IEEE 802.3) Ethernet technology. This part of the IEC 62439 series specifies a redundancy protocol that is based on the duplication of the network, the redundancy protocol being executed within the end nodes, as opposed to a redundancy protocol built in the switches. Fast error detection is…

IEC 62439-5:2016 concerne les réseaux de haute disponibilité pour l'automation qui reposent sur la technologie Ethernet ISO/IEC/IEEE 8802-3 (IEEE 802.3). La présente partie de la série IEC 62439 porte sur un protocole de redondance qui repose sur la duplication du réseau; ce protocole est exécuté dans les noeuds d'extrémité, par opposition à un protocole de redondance intégré aux…

ISO 13400-4:2016 specifies a minimum set of diagnostic Ethernet connector requirements which are based on ISO 15031‑3. The ISO 15031‑3 diagnostic connector is referenced by legislation in many countries. The diagnostic connection specified in this part of ISO 13400 consists of two mating connectors: the vehicle connector and the external test equipment connector as specified in ISO 15031‑3. ISO…

ISO 27145-4:2016 defines the requirements to successfully establish, maintain and terminate communication with a vehicle that implements the requirements of the WWH-OBD GTR (Global technical regulation No. 5; see Reference [16]). This requires plug and play communication capabilities for the vehicle, as well as for any test equipment that intends to establish communication with a vehicle. This…