Rechercher

1.1 This Standard applies to arc fault protective devices designed to be installed in accordance with the Rules of the Canadian Electrical Code, Part I. 1.2 These devices include arc fault circuit interrupters (AFCI) and devices that incorporate arc fault circuit protection for use on single phase, 120 V, or single phase, two-pole, three-wire 120/240 V alternating current, 60 Hz circuits…

This Standard applies to cord-connected, electrically heated warming pads with associated control units, for household and hospital use, to be used in nonhazardous locations, designed for nominal 120 V ac circuits, in accordance with the Canadian Electrical Code, Part I.

1.1 Purpose This Standard establishes minimum requirements for electrical work and electrical equipment operating, or intended to operate, at a mine. Note: Users should be aware that federal, provincial, and territorial legislation can impose additional requirements. 1.2 Application This Standard is supplementary to, or amendatory of, the requirements of the Canadian Electrical Code, Part…

1.1 This Standard describes the design, construction, load rating, installation, erection, inspection, maintenance, repair, modification, test, and operation of lattice and telescopic boom mobile cranes. Note: See Annex A for illustrations of mobile cranes and Annex B for illustrations of parts of a mobile crane. 1.2 This Standard applies only to machines that have all of the following…

1.1 Application This Standard applies to single- and multi-section buildings supported on longitudinal floor beams, or perimeter rim joists designed to perform as beams. 1.2 Issues addressed This Standard specifies requirements for the following aspects of building installation: a) site preparation; b) permanent foundations; c) anchorage to resist overturning and pier toppling due to wind…

This Standard specifies requirements for the mechanical, electrical, and environmental performance of connectors designed for installation on the bare surface of overhead line conductors at normal operating temperatures up to 100 °C. Note: Although the requirements of this Standard were developed primarily for connections to aluminum conductors, the requirements are also applicable to connectors…

This part of ISO/IEC 23008-3 specifies technology which supports the efficient transmission of 3D audio signals and flexible rendering for the playback of 3D audio in a wide variety of listening scenarios. These include 3D home theater setups, 22.2 loudspeaker systems, automotive entertainment systems and playback over headphones connected to a tablet or smartphone.

This service definition is compliant with the UPnP Device Architecture version 1.0. This service type enables control over the transport of audio and video streams. The service type defines a ‘common’ model for A/V transport control suitable for a generic user interface. It can be used to control a wide variety of disc, tape and solid-state based media devices such as CD players, VCRs and MP3…

This service definition is compliant with the UPnP Device Architecture version 1.0. This service-type encapsulates the management of an out-of-band remoting protocol connection to a device capable of user interaction. This service is required for all Remote UI clients. It is specified in: urn:schemas-upnp-org:device:RemoteUIClientDevice

ISO 2974:2016 specifies the dimensional requirements of end-connections for high-pressure fuel injection equipment components used on diesel (compression-ignition) engines. It is applicable to externally threaded 60° female cones (see Figures 1, 2, 5, and 6) and intended for use with high-pressure fuel injection pipe assemblies with tube outside diameters of - up to and including 12 mm for…