Rechercher

ISO/IEC 29341-24-10:2017 specifies the characteristics of the UPnP networked service named WANIPConnection, version 2. This service definition is compliant with UPnP Device Architecture 1.0 [1] . It is one component of the Device Control Protocol for the UPnP Internet Gateway Device (see [3]). This service enables a UPnP control point to: - configure and control an IP connection…

ISO/IEC 29341-26-10:2017 is compliant with [1]. It defines a service type referred to herein as the CallManagement service. The CallManagement service is a UPnP service that allows control points to use the telephony features(e.g., voice call, video call, and data transfer etc.) provided by a Telephony Server (TS). The CallManagement service enables the following features to a Telephony Control…

ISO/IEC 29341-20-11:2017 is compliant with the UPnP Device Architecture version 1.0 [14]. This service-type enables modeling of streaming capabilities of A/V devices, and binding of those capabilities between devices. Each device that is able to send or receive a stream according to the UPnP AV Architecture will have 1 instance of the ConnectionManager service. This service provides a mechanism…

ISO/IEC 29341-24-2:2017 specifies the characteristics of the UPnP networked device named WANConnectionDevice, version 2. This device definition is compliant with UPnP Device Architecture 1.0 [14] and UPnP Device Architecture 1.1 [15].

ISO 9836:2017 specifies the definition and calculation of surface area and volume indicators. In defining area measurement, ISO 9836:2017 uses three measurement concepts: a) the intra-muros and extra-muros concept used in many parts of the world; b) the wall centre method of measurement used in many parts of the world; c) variations on these methods to comply with certain national laws…

ISO 7240-18:2017 specifies requirements, test methods and performance criteria for input/output devices connected to a transmission path of a fire detection and alarm system used to receive and/or transmit signals to or from the transmission path, necessary for the operation of the fire detection and fire alarm system and/or fire protection system. An input/output device can be a physically…

1.1 Introduction 1.1.1 The purpose of this standard is to provide minimum requirements for the design, construction, and marking of electrical equipment or parts of such equipment for use in Class I and Class II, Division 2 and Class III, Divisions 1 and 2 hazardous (classified) locations. 1.1.2 This equipment, in normal operation, is not capable of causing ignition of the surrounding…

1.1 This Standard applies to motor-operated vacuum cleaners and blower cleaners, floor sweepers, and to household use floor finishing machines to be employed in accordance with C22.1, C22.2 No. 0, and ANSI/NFPA 70. 1.2 These requirements cover: a) Household, commercial, and coin-operated vacuum cleaning machines and blower cleaners, intended for indoor or outdoor use or both; b) Household,…

1.1 The requirements of this standard cover holders and connectors for electric lamps, including incandescent, fluorescent, and other electric-discharge-type lamps, rated as indicated in Clause 6, to be used in accordance with the Canadian Electrical Code (CEC), Part I, C22.1, and the National Electrical Code (NEC), ANSI/NFPA 70. 1.2 These requirements cover screw lampholders, including those…

ISO/TR 24679-4:2017 provides a fire engineering application relative to the fire resistance assessment of a fifteen-storey steel framed building following the methodology given in ISO 24679-1. This document describes the adopted process which follows the same step by step procedure as that provided in ISO 24679-1. The annexes of this document present the detailed assessment results obtained for…