Rechercher

This standard defines PHY and MAC specifications for high data rate wireless connectivity (typically over 200 Mbps) with fixed, portable, and moving devices. Data rates are high enough to satisfy a set of consumer multimedia industry needs, as well as to support emerging wireless switched point-to-point and high rate close proximity point-to-point applications.

This Standard specifies the requirements for stay in place, modular expanded polystyrene (EPS) Insulating Concrete Form (ICF) units. Once filled with concrete, the ICF units remain in place as the thermal insulation for the resulting cast-in-place concrete wall of uniform cross-section and thickness. The requirements of this Standard apply to ICFs that act as permanent formwork for cast-in-…

1.1 This Standard specifies energy efficiency and performance requirements for LED luminaires of the directional and non-directional type used for general illumination, including commercial and residential, indoor and outdoor, as well as those with a significant decorative function. Notes: 1) White tunable luminaires and connected luminaires are included in the scope of this Standard. 2)…

1.1 This Standard applies to newly produced, direct-fired construction heaters, hereinafter referred to as heaters or appliances, constructed entirely of new, unused parts and materials and primarily intended for temporary use in heating buildings or structures under construction, alteration, or repair. All the products of combustion generated by the heater are released into the area being…

1 Scope 1.1 This Standard applies to newly produced, gas-fired high-intensity infrared heaters (see Clause 3, Definitions), hereinafter referred to as heaters or appliances, constructed entirely of new, unused parts and materials with inputs up to and including 400,000 Btu per hour (117 228 W) per burner: a) for use with natural gas; b) for use with manufactured gas; c) for use with mixed…

This part of IEC 61058 applies to switches for appliances. The switches are intended to control electrical appliances and other equipment for household or similar purposes with a rated voltage not exceeding 480 V and a rated current not exceeding 63 A. Switches for appliances are intended to be operated by – A person via an actuating member, – Indirect actuation, – An actuating sensing unit…

1.1 These requirements cover EV plugs, EV receptacles, vehicle inlets, vehicle connectors, and EV breakaway couplings, rated up to 800 amperes and up to 600 volts ac or dc. These devices are intended for use with conductive electric vehicle supply equipment (EVSE), and are intended to facilitate the conductive connection from the EVSE to the vehicle. These devices are for use in either indoor…

ISO 17836:2017 specifies a test procedure to determine the deposition efficiency for thermal spraying. It provides a reliable comparison method between different spray processes and different feed stock. It is applicable for all thermal spray processes (see ISO 14917) and all wire, rod, cord and powder spray materials. It is applicable when data concerning the deposition efficiency of a spray…

ISO 18674-3:2017 specifies the measurement of displacements across a line by means of inclinometers carried out for geotechnical monitoring. General rules of performance monitoring of the ground, of structures interacting with the ground, of geotechnical fills and of geotechnical works are presented in ISO 18674‑1. ISO 18674-3:2017 also refers to deflectometers (see Annex B) to supplement…

ISO 11363-2:2017 specifies types, dimensions and principles of use of gauges, to be used in conjunction with the taper threads specified in ISO 11363-1 (i.e. 17E and 25E threads). It provides examples of calculations for thread gauge dimensions on the large end diameter (Annex A) and draws attention to the limitations of the gauging system specified (Annex B).