Ships and marine technology — Boil-off-rate measurement method for cargo containment system of LNG s...
This document specifies the principle, condition, equipment, process, data acquisition and processing and test report of BOR(Boil-off-Rate) test. It is applicable to the CCS(Cargo Containment System) of LNG carrier,LNG FSRU, LNG bunkering vessel and also for the CCS of LNG fuel ships.
Plastics moulded parts — Tolerances and acceptance conditions
This document specifies possible manufacturing tolerances for plastic moulded parts.
This document specifies all integral features with general tolerances with surface profile tolerance within a specified datum system. It allows for additional specifications in case of functional needs and requirements using the ISO-GPS-tools for dimensional and geometrical tolerating.
This document addresses…
Road vehicles — Controller area network (CAN) — Part 2: High-speed physical medium attachment (PMA) ...
This document specifies physical medium attachment (PMA) sublayers for the controller area network (CAN). This includes the high-speed (HS) PMA without and with low-power mode capability, without and with selective wake-up functionality. Additionally, this document specifies PMAs supporting the signal improvement capability (SIC) mode and the FAST mode in Annex A. The physical medium dependent (…
Cards and security devices for personal identification — Contactless proximity objects — Part 3: Ini...
This document describes the following:
- polling for proximity cards or objects (PICCs) entering the field of a proximity coupling device (PCD);
- the byte format, the frames and timing used during the initial phase of communication between PCDs and PICCs;
- the initial Request and Answer to Request command content;
- methods to detect and communicate with one PICC among…
Binders for paints and varnishes — Determination of softening point — Part 3: Cup method (without a ...
This document specifies a method for determining the softening point of resins (including rosin) and can, under user-defined conditions, give results comparable to those obtained by ISO 4625-1 and ISO 4625-2.
Acoustics — Hearing aid fitting management (HAFM) — Part 1: General process
This document applies to hearing aid fitting management (HAFM) services offered by hearing aid professionals (HAP) when providing benefit for their clients. The provision of hearing aids relies on the knowledge and practices of a hearing aid professional, to ensure the proper fitting and adequate service in the interest of the client with hearing loss.
This document specifies general processes of…
Assembly tools for screws and nuts — Hand torque tools — Part 2: Requirements for calibration and de...
This document specifies the method for the calibration of hand torque tools and describes the method of calculation of measurement uncertainties for the calibration.
It also specifies the minimum requirements for a certificate of calibration to this standard for hand torque tools.
The Annex C of this document specifies the minimum requirements for the calibration of the torque measurement device…
Privacy protection — Guidance on the use of models for privacy engineering
This document provides guidance on how to use modelling in privacy engineering.
It describes categories of models that can be used, the use of modelling to support engineering, and
the relationships with other references and standards for privacy engineering and for modelling.
It provides high-level use cases describing how models are used.
Additive manufacturing — Qualification Principles — Framework for categorizing resources and process...
This document defines a standardized framework for implementing a level system for temporarily self-sufficient systems in additive manufacturing. It defines principles, criteria, and provides guidance for categorizing additive manufacturing processes and technologies into different levels to support self-sufficient systems such as ships, oilrigs and assembly teams in the field or remote research…
Reactor technology - Design and performance evaluation of the emergency core cooling system strainer...
This document specifies the general principles and requirements for the design and performance evaluation of emergency core cooling system (ECCS) strainer of the pressurized water reactor (PWR) nuclear power plant, including the debris source walkdown, upstream analysis, the design of the sump strainer equipment, and the debris head loss test and analysis, Chemical effect test and analysis,…
