Rechercher

Method is established in terms of temperature, relative humidity and time to reach equilibrium. Possible deviations from the standard reference atmosphere are mentioned. The procedure is applicable to all types of dry leather.

1. Scope 1.1 This Standard establishes a uniform relationship between shaft size and key size for parallel and taper keys. 1.2 This Standard covers the size, type and tolerances of paralle l and taper keys, and their relationship to shaft diameters and bore diameters. The size and tolerances contained in this Standard are intended for single key application only, except tangential…

1. Scope 1.1 This Standard applies to cord-connected electric clocks intended for use in household and other ordinary (non-hazardous) indoor locations in accordance with the rules of the Canadian Electrical code, Part I, and having a rating not exceeding 125 volts a.c. and 30 watts input. 1.2 This Standard includes household clocks with and without alarms and dial lights, and digital…

1. SCOPE 1.1 This Standard states the minimum requirements for nozzles which are designed for installation in oil burners of the pressure atomizing type. 1.2 This Standard includes requirements for construction, marking, and performance to ensure consistent operation of nozzles. 1.3 The intent of these requirements is to determine the consistency of flow rate, nominal spray angle,…

Describes the standard method of measurement of lamp cap temperature rise which is to be used when testing tungsten filament or discharge lamps for compliance with the limits. Covers the method of test and the specifications for test lampholders for lamps fitted with various sizes of ES and BC caps. This method has been used widely for incandescent lamps but its application is not limited to that…

Intended for type tests and acceptance and factory tests. The performance characteristics measured in accordance with this standard make it possible to compare the results of measurements made by different observers.

1. Scope 1.1 This Standard gives tables of standard tolerances for linear dimensions in both inch and metric units, covering a range of sizes up to 200 inches or 5,000 millimetres. Tolerances are provided in a series of grades which cover the full range of precision, from ultra precise products such as gauging elements to coarse tolerances suitable for rough work, and for many types of…

1. SCOPE 1.1 This Standard applies to cord-connected room air conditioners rated not more than 250 volts, single phase, with a rated capacity not over 36,000 Btu/hr, designed to be used in accordance with the Rules of Canadian Electrical Code, Part I. 1.2 This Standard applies to self-contained air-cooled window, or console or built-in-wall type room air conditioners, which have…

Establishes uniform requirements for judging the electrical, mechanical and climatic properties of capacitors, describes test methods and gives recommendations for standard dimensions and classification into categories,

Lays down requirements for flexible or semi-flexible radio-frequency cables of coaxial or twin conductor types designed for use in radiocommunication equipment and in electronic devices employing similar techniques. The dielectric may be of the solid, air-spaced, or semi-airspaced types, consisting of a thermoplastic of low-loss polymeric resin or of a thermosetting compound, or of a mineral…