Rechercher

The rules are valid for the following type of certification system: a third party certification system of determining conformity with product standards through initial testing and assessment of a factory quality management system and its acceptance followed by surveillance (corresponds to system No. 5 as described in ISO/ITC publication "Certification - Principles and practice"). A…

Applies to one-component joint sealing compounds that cure to a rubber-like solid and are suitable for sealing, caulking or glazing applications. A sealing compound meeting the requirements of this standard is designated by the manufacturer to be one or more of the types, classes, grades, and uses defined in Section 3 of this standard. For application on a particular substrate the primer,…

This international Standard specifies the dimensions and characteristics of the general purpose daylight loading spool with a nominal capacity of 30 m (100 ft) for use in 35 mm motion-picture cameras. NOTE - The dimensions specified in this International Standard are in substantial agreement with corresponding dimensions for microfilm Camera spools described in ISO 1116 (sec the annex).

1. Scope 1.1 This Standard sets forth the requirements for the construction, test, and operation of permanently or cord-connected 120 V ac detertors and 12 V dc deterctors, intended for use in the home and in recreational vehicles, for the detection of fuel gases (natural gas, methane, and propane), in accordance with the Canadian Electrical Code, Part I. No other function is implied or…

1.1 Scope 1.1.1 This standard applies to propane and natural gas-fired unattended portable type infra-red heaters (see Definitions, Part III), hereinafter referred to as heaters with gas inputs up to and including 400 000 Btuh (117.23 kW). 1.1.2 The standard applies to portable unvented infra-red heaters used primarily for temporary heating purposes. 1.1.3 Portable type…

Establishes a general system for designating the intensity, quantity and size of common types of defects and outlines the basic principles of the system in respect of designation of the intensity, quantity and size of defects. A uniform convention has been adopted for designating the intensity and quantity of defects: "o" denoting no defects, and "5" denoting defects so severe…

This document provides pictorial standards for designating the degree of blistering. The principle of the method consists in rating the density and size of the blisters by means of the pictorial standards. The photographic reference standards have been adopted from ASTM D 714-56. Replaces and cancels section two of ISO 4628/1-1978.

This document provides pictorial standards for designating the degree of rusting. The standards given are basically indended for rating on coated steel. They may used for designating the degree of corrosion of non-ferrous metals if the form of breakdown is comparable with that on the standards. Cancels and replaces section three of ISO 4628/1-1978.

Provides pictorial standards for designating. The quantity of cracking is rated by reference to table 2 of ISO 4628/1 and using as examples figures 1 or 2, depending on the type of cracking. The average size of the cracks is designated according to the classification.

Provides pictorial standards for rating of flaking. The quantity of damage is rated on the basis of the relative area flaked, by reference to table 1 and using the figures 1 and 2 as examples.