Aerospace — Omega clamps (saddle clamps) for fluid systems — Dimensions
Includes maximum and minimum dimensions for clamps installed by means of two bolts with nominal diameters of 5 mm. The specified dimensions define a dimensional envelope. Shall not be considered as an interchangeability standard. The tolerances for each type of clamp are to be defined in the parts standards drawings. These clamps are intended for the installation, support and guiding of rigid…
1. Scope
1.1
This Standard applies to insulated pressure wire connector type cable splicing
kits for use with underground cables intended for direct earth burial, and for
use with conductors rated at 90°C and 600 V or less, in accordance with the
Canadian Electrical Code, Part I.
1.2
The cable splicing kits include the following:
(a) pressure wire connectors intended for use with…
Specifies the characteristics of products without (type A) and with split pin holes (type B) with metric dimensions and nominal diameters from 3 mm up to and including 100 mm with reference to International Standards; gives examples for the designation.
Specifies the characteristics of products without (type A) and with split pin hole (type B) with metric dimensions and nominal diameters from 3 mm up to and including 100 mm; includes specifications with reference to International Standards; gives examples for the designation.
Aircraft — Magnetic indicators — Part 1: Characteristics
Specifies the general operating characteristics and standardization principles. Lays down the basic requirements relating to the mechanical and electrical characteristics as well as the basic environmental conditions in service. ISO 5065-2 gives details of the tests referred to in this part of ISO 5065. Includes design requirements, type approval testing and production and quality testing.
Electrically Heated Hobby and Educational Type Kilns
1. Scope
1.1
This Standard applies to cord-connected and permanently connected electrically
heated pottery kilns for use on nominal system voltages of 600 V or less,
designed to be used in accordance with the Rules of the Canadian Electrical
Code, Part I.
1.2
This Standard does not apply to electrical equipment employing high-frequency
currents or industrial heating equipment.
Rubber — Determination of adhesion to rigid materials using conical shaped parts
Adhesion is obtained by a bonding system which may include not only the rigid material and the rubber compound, but other elements, e.g. thin alloy coatings etc. The bonding system should be adequately specified by the user, but the standard provides for evaluation of differnt types of failure related to a complex adhesion system. The standard test piece is given in a figure, the test report is…
Wrenches, Box, Open End, and Combination (Inch Series)
1.1
This standard is intended to cover the complete general and dimensional
data for nickel-plated nonadjustable wrenches used for tightening and loosening
(Inch Series) bolts and nuts.
1.2
This standard does not include all types and sizes of the commodity indicated
by the titles of this standard, nor all those commercially available, but
includes only those generally used by the Federal…
Textile glass — Rovings — Basis for a specification
Is intended to serve as a guide for the establishment of technical specifications for products of given type. Rovings are divided in two main groups: - rovings that are chopped during subsequent operations - rovings that are utilized without being chopped The following particulars are mentioned and the relevant International Standards are quoted: Designation, type of glass, filament diameter,…
