Rechercher

1. Scope 1.1 This Standard applies to dry type, air-cooled transformers, autotransformers (fixed and variable), and primary-circuit reactors intended for use in, on, or associated with other approved equipment in capacities of 1000 kV·A and less and for primary voltages of 750 V or less, 60 Hz and less, and intended for use in nonhazardous locations in accordance with the Canadian…

1. Scope 1.1 This Standard applies to ac and dc motors with inherent overheating protection designed to be used in accordance with the Rules of the Canadian Electrical Code, Part I, as follows: (a) motors with a voltage rating not exceeding 600 V and with a protective device connected in the motor circuits; (b) impedance protected motors with a voltage rating not exceeding 600 V; and (c…

1. Scope 1.1 This Standard applies to insulated conductors intended for internal wiring in electrical equipment, but not as circuit conductors for use in raceways except where permitted by the Canadian Electrical Code, Part I. 1.2* Constructions covered by this Standard are (a) single-conductor, thermoplastic-insulated (Clause 5): (i) Type TXF, 60

Specifies maximum and minimum dimensions for these clamps installed by means of a bolt with a nominal diameter of 5 mm. The specified dimensions define a dimensional envelope. Shall not be considered as an interchangeability standard. The tolerances for each type of clamp are to be defined in the parts standards drawings.

La présente Norme internationale fixe les cotes maximales et minimales des colliers en P fixés à l'aide d'une vis de diamètre nominal 5 mm. Les dimensions fixées définissent une enveloppe dimensionnelle. La présente Norme internationale ne doit pas être considérée comme une norme d'interchangeabilité. Les tolérances pour chaque type de collier sont à définir dans les dessins de…

1. Scope 1.1 This Standard applies to locking type plugs, receptacles, equipment power inlets and outlets, and connectors rated up to 60 A and up to 600 V ac or 250 V dc, for use in accordance with the Canadian Electrical Code, Part I. 1.2 The devices covered by this Standard are intended for use with copper conductors only in making readily detachable electrical connections utilizing a…

1. Scope 1.1 This Standard applies to plugs, receptacles, power inlets and outlets, connectors, and similar wiring devices intended for use in electronic and electrical applications as follows (see Figure 1): (a) Type 0 rated up to 8.3 A and up to 30 V rms (42 V peak); (b) Type 1A rated up to 8.3 A and from 30 V to 600 V ac or dc, or both; (c) Type 1B rated from 8.3 A up to 200 A and up…

The methods given are applicable to increment sampling of consignments supplied both in bulk and in packed form during loading or unloading, and to sampling of consignments in stationary stockpiles. Specifies the methods of both manual and mechanical sampling. Should be read in conjunction with the relevant International Standards for individual types of ferroalloys.

1. Scope 1.1 This Standard specifies a set of technical requirements and test methods for solar collectors and covers component materials, materials performance, operating performance, and marking requirements. 1.2 This Standard applies to solar collectors used for conver ting solar radiation into thermal energy. It covers only collectors with an aperture area of not less than 0.5 m²…

Deals with the definitions, the conditions and the methods of measurement used to ascertain the performance of receivers having audio-frequency bandwidths generally not exceeding 10 kHz for the reception of voice and other types of signals, using single-sideband amplitude modulation. The standard is intended to be used in conjunction with IEC 60489-1.